boat
Likes blue ones
For sale is my 90 SHO, blue on black.
Some history of the car:
Previous history: Timbo
Removed dead engine (3.2) installed an 80k mile 3.0 from a California 89
Installed gen 3 subframe bushings
Replaced plugs & wires
Valve lash
Pass side trans axle seal replaced
Installed gen 1 hard button eatc.
This was Calypso's old gen 1, and Dave Kliegel made this car the first 3.2 mtx swap. Previous owner to timbo, that 3.2 had locked up.
This is what's been done by me, during my ownership for the last 2 years.
Now riding on slicers and tires all season performance tires with about 80% tread left
New O2 sensors
New idle air sensor
New battery
New Reman'd alternator
New front brakes, discs and pads
Replaced X2J PCM
Replaced p/s rack
CCRM - relay module
EEC Harness - from PCM to CCRM
Installed correct radiator fan
All 4 struts replaced with good low mileage motorcraft stock struts
Replaced Front LCA's
Replaced front strut rod bushings
Replaced bad left front knuckle
Replaced wheel bearing in replaced left front knuckle
Replaced front pads and discs
4 wheel alignment
Repaired a coolant leak
Fresh oil change at 130k
Installed black gen 2 50/50 seats
Re-installed stock black 90 steering wheel
Installed a Kenwood mp3/CD player and DIN Bin
Replaced some of the door clips
Replaced ignition cylinder
Mods
Stainless brake lines
96 brakes
Super blue brake fluid - what I have left in a can will be included
Adjustable rear control arms
H-brace
What the car needs
Front main is leaking
Functional airbag circuit. This was previously before Timbo, racing steering wheel was put in
Horn setup to be functional
Trans grinds in 1st and 2nd
What's included in the price
The car
Refreshed MTX
Full set of gen 3 chromies on 70-80% summer tires
New fog lights - not installed
90 cruise control diaphragm with hoses
90 clock spring
Taylor 8.8mm wires 20k miles
Spare DIS
Spare coil pack
Front 60k parts - enough to do full front service
New Timing belt tensioner
New timing belt
2200 mile stock Dayco serpentine belts- both
Low mileage water pump
Low mileage crank sensor
Extra cam sensors
0 mile cam seals (were installed but taken out before different engine was ran)
20k mile stock clutch and TOB, stock flywheel and new rear main seal
94-95 alt bracket
Spare m code ccrm
Spare upper radiator hose
0 mile rod bearings
New thermostat
Any gen 1 specific parts I have.
Some pictures:












The pics of the interior, sorry for the graininess of them. I took them at sunset.
The carpet was replaced at some point with aftermarket carpet, it doesn't fit well. I do realize the car is dirty at this point, I can get it cleaned up if a sale is involved.
$1500 or best offer. I am not interested in any trades, cash deal gets you everything listed here. As price is negotiated down, parts will disappear from this list. I am getting out of the SHO game, the time has come to move on to other things.
Some history of the car:
Previous history: Timbo
Removed dead engine (3.2) installed an 80k mile 3.0 from a California 89
Installed gen 3 subframe bushings
Replaced plugs & wires
Valve lash
Pass side trans axle seal replaced
Installed gen 1 hard button eatc.
This was Calypso's old gen 1, and Dave Kliegel made this car the first 3.2 mtx swap. Previous owner to timbo, that 3.2 had locked up.
This is what's been done by me, during my ownership for the last 2 years.
Now riding on slicers and tires all season performance tires with about 80% tread left
New O2 sensors
New idle air sensor
New battery
New Reman'd alternator
New front brakes, discs and pads
Replaced X2J PCM
Replaced p/s rack
CCRM - relay module
EEC Harness - from PCM to CCRM
Installed correct radiator fan
All 4 struts replaced with good low mileage motorcraft stock struts
Replaced Front LCA's
Replaced front strut rod bushings
Replaced bad left front knuckle
Replaced wheel bearing in replaced left front knuckle
Replaced front pads and discs
4 wheel alignment
Repaired a coolant leak
Fresh oil change at 130k
Installed black gen 2 50/50 seats
Re-installed stock black 90 steering wheel
Installed a Kenwood mp3/CD player and DIN Bin
Replaced some of the door clips
Replaced ignition cylinder
Mods
Stainless brake lines
96 brakes
Super blue brake fluid - what I have left in a can will be included
Adjustable rear control arms
H-brace
What the car needs
Front main is leaking
Functional airbag circuit. This was previously before Timbo, racing steering wheel was put in
Horn setup to be functional
Trans grinds in 1st and 2nd
What's included in the price
The car
Refreshed MTX
Full set of gen 3 chromies on 70-80% summer tires
New fog lights - not installed
90 cruise control diaphragm with hoses
90 clock spring
Taylor 8.8mm wires 20k miles
Spare DIS
Spare coil pack
Front 60k parts - enough to do full front service
New Timing belt tensioner
New timing belt
2200 mile stock Dayco serpentine belts- both
Low mileage water pump
Low mileage crank sensor
Extra cam sensors
0 mile cam seals (were installed but taken out before different engine was ran)
20k mile stock clutch and TOB, stock flywheel and new rear main seal
94-95 alt bracket
Spare m code ccrm
Spare upper radiator hose
0 mile rod bearings
New thermostat
Any gen 1 specific parts I have.
Some pictures:












The pics of the interior, sorry for the graininess of them. I took them at sunset.
The carpet was replaced at some point with aftermarket carpet, it doesn't fit well. I do realize the car is dirty at this point, I can get it cleaned up if a sale is involved.
$1500 or best offer. I am not interested in any trades, cash deal gets you everything listed here. As price is negotiated down, parts will disappear from this list. I am getting out of the SHO game, the time has come to move on to other things.
Last edited:
