removing abs

[sho85]

I have a 94 mtx sho and i removed the abs system but im still left with the harness and all its strands.i didnt really follow the harness back as im working out side and it started to snow. But does it disconect anywhere? Also running new brake lines how should i go about doing that?

 

[quikSHOilver]

Not much you can do as the ABS harness integrates with body harness. If you want the bulky ABS HCU connector and wiring gone, then you would need to refer to EVTM manual and dissect to remove ABS wiring like I did for my track.

It was quite a steep learning curve for me that time. If I was to do that again, yes I would.

For the brake line you can use 3 way tee fitting for front. For rear, You would be better off add porportional valve such as wilwood brand or equivalent and run one line from porportional valve to again using 3way tee fitting
Happy SHO'!

 

[sho85]

So basicly front port from master to a tee then to front brakes then back port from master to por valve to to tee then to rear calipers.?

 

[sperold]

You would follow the plumbing that the regular Taurus uses if you get rid of the ABS system. Go online or get a manual to get that done. You would have to confirm that the master cylinder is adaptable.
If you stick with the ABS, you can buy all the lines from Shonut who has an advertisement on this forum, and they are stainless steel.