Oxygen Sensor

[Porod]

I found out what the different part numbers at autozone were. The only difference between part #15716, part #15717, and part #15718 is the length of the connecting wire. -16 is an 8 1/2 in. wire, -17 is an 11 inch wire, and -18 is a 13 inch wire. That is all. The sensors are the same. Had I realized this, I would have never needed to post about this. Thanks.

 

[Porod]

I got the front one changed with a minimum of fuss, but I am not sure about the back one. My arm is not fitting between the engine and the firewall, at least not unless I take off some stuff (there is a black plastic cover that I could try to get off). Even if I get the sensor loose, I think that I will need to be under the car to unclip the cord from its mating part. Any imput here would be of help. (I can see the sensor from the top by laying across the intake)

 

[Porod]

Nevermind! I now have both o2 sensors installed!

 

[Bizzy]

Porod:
Nevermind! I now have both o2 sensors installed!

Woo Hoo! Do you notice a big difference now?

<small>[ September 29, 2002, 04:26 PM: Message edited by: Bizzy ]</small>