So normally I'm not picky about stuff missing, like on an older car. But after coming back from picking up dinner and showing a friend my car i automatically noticed that one of my sensors for the parallel park assist (front bumper cover) left the chat. At the moment I don't have a picture to better describe it. All I could do was poke my finger into the hole and I couldn't feel anything. So A. It's fallen into the cavity or B it fell out and onto the road somewhere. What the ****. Being Michigan our roads aren't the best. But it would have to be a very jarring bump to knock out that small sensor. No issues electronically and no dash warnings. *insert derp moment here* so not much i can do other than cover it with something but that may hamper proper operation of the system even though I have not used it for parallel parking. Rant over. I know, stupid minor thing but the off chances I'll ever use this feature are slim. Anyone ever had this happen?
Missing Front Right Parallel Parking Assist Sensor 2015 SHO
- Thread starter Jake0811
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Nope its most likely behind the bumper cover, time to take it off.
Most likely. I do have to figure out why my passenger side headlight comes on and goes out so that's an excuse to take that bumper off. Nothing i can't fix! I'm certain these bumpers are just held on by two bolts and several push pin retainers. Sides, top, and the bottom?
Not hard to take off and it's pushed into some clips that hold it in place when putting it on, taking it off is a pull snap out. Several screws on top, bottom and wheel well.
Ditto, thanks man!
Similar threads
