How do I tighten the crank pulley bolt?

[philjw90SHO]

I have a 92 MTX with 107k and I am just about to start the 60k service and I have been to shotimes to see how to remove everything. But i am unclear on how to tighten the crank pully bolt back up. Do I just tighten it as much as I can or is there a special way to get it nice and snug
again.

Thanks

 

[pjtoledo]

philjw90SHO:
I have a 92 MTX with 107k and I am just about to start the 60k service and I have been to shotimes to see how to remove everything. But i am unclear on how to tighten the crank pully bolt back up. Do I just tighten it as much as I can or is there a special way to get it nice and snug
again.

Thanks

Just put the tranny in 4 or 5th, step on the brakes, crank the bolt to about 125 Lbs/ft.

Perry Toledo,Ohio

 

[luigisho]

I would put that side on the ground with the spare donut on it too. Don't forget loktite on the threads.

 

[Deaks2]

I used my impact wrench @ 120 lbs, that worked nice...