FrOsTyShO
New Member
Here they are, my halo's. Sorry about the delay!
Halo Guage Pics!!!
- Thread starter FrOsTyShO
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
93ATX SHO OFF
New Member
They look good, where did you get them? Although, it does look like she's heating up a bit in the first pic...
ShoGuy93
Yes I Have Blue Rims
Looks good man. And i love the blue neons. But i got a question. I just got the indglos off of ebay. and i was wondering did u have take out the lights in the console where the old gauges was??
nothingtoseehere
SHO Member
- Joined
- Apr 23, 2001
- Messages
- 2,483
- Reaction score
- 1,192
I just put the Halos in as well....you do not have to remove any of the lkighting for these. The slide right over your existing gauge and have their own light source.
FrOsTyShO
New Member
It does LOOK like the engine is really, hot but I don't think I put the needle back on right because when the car is not running the needle goes all the way to the top. He's right. Don't touch the stock setup. Just slide these right over.
nothingtoseehere
SHO Member
- Joined
- Apr 23, 2001
- Messages
- 2,483
- Reaction score
- 1,192
Did you actually take the needles off? I just slid all three gauges over the needles....all my gauge needles are the same as when I started....
jcostantino
New Member
You might have swapped the temp and fuel needles around... I think the counterweights are different. My fuel needle droops down when I have less than 3/4 tank and I think I broke my temp gauge (have another temp gauge tho)...
Oh well.. one day I'll take the dash off (again) and fix the fuel level.. put the needle on a little low.
Jeff
Oh well.. one day I'll take the dash off (again) and fix the fuel level.. put the needle on a little low.
Jeff
Hubes
New Member
how much you pay for them. they look nice. i guess a cheaper alternative to speedhut's gauges. how hard was the intsall?
jcos my gas needle doens't work at all.
jcos my gas needle doens't work at all.
nothingtoseehere
SHO Member
- Joined
- Apr 23, 2001
- Messages
- 2,483
- Reaction score
- 1,192
I paid 78.99 total (that was the cost of the gauges and shipping) They go on SUPER easy. They just slide over your existing gauges. Then just splice the power into the power (red with yellow stripe) on your headlight swithc and run a ground and you are all set. The most time consuming part is taking the dash apart.
Similar threads
