Anyone know the dimensions of the 4 mounting points on a Gen 3 cradle? Need the center-to-center width at front and rear, and the distance front-to-rear. Am I correct in my belief that the cradles are the same from gen 1-3? Lastly, anyone in the Los Angeles area have a cradle for sale?
Engine cradle question(s)....
- Thread starter rnddude
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
kevinspann
Don't take my advice.
They are not the same 1-3, but the measurements you want are the same between all three of them (gen 1 and 2 are the same, gen 3s are different, but still have the same mounting points)
One last question, was there a non-SHO V8 offered in Gen 3 models, and if so, is the subrame different/same? I have several dismantlers claiming they have the SHO subframes to sell, but i'm not so sure they are correct. Please advise....
tqmx1
New Member
The V8 was 96/99 Sho only. All the others were V6 Vulcan or Durtech 3.0s.
93rev2sev
SHO Member
The masurement's you're talking about are the same for all Taurus gens 86-07. Engine mount points are dependent on the engine, but body mount points are all the same.
I know that was stated and you want the measurements...I'll have them later tonight.
I know that was stated and you want the measurements...I'll have them later tonight.
Last edited:
Similar threads
