Dumb

[Boochy47]

Yo Boyz I really wanna get my AEM water meth system all running but last owner unplugged but it’s still laced but I’m pretty sure he tapped into washer fluid tank because it didn’t hold fluid has slow leak somewhere idk if my Machanic knows much or at all about these systems an I’m sick of seeing light for fluid I wanna get it fixed but also don’t wanna get bent over a barrel and shown the fifty states any idea on what it should cost? I wanna keep aem right?

 

[DadMobile]

As far as methanol systems go the AEM and SNO stuff is probably the easiest for a mechanic to install. Other than the controller have looked for the pump, lines, and nozzle? If you have everything in the car but it’s just disconnected then any reputable performance shop in your area should be able to knock it out in about 2 hours. Methanol is great but you definitely need to watch some YouTube videos on it to understand a bit more how it works if your unsure.

You’ll want to learn how to purge it, how to set it up based off your boost levels, which nozzle to run etc. What fluid mix to run etc.

You can always start with a small 250cc nozzle and work up. Depending on the mix and nozzle size the engine will love the effects of the methanol and you will get a noticeable power increase.

 

[Boochy47]

I’ll keep you posted I definitely want I functioning where do I get the juice ?

 

[Boochy47]

I’m excited

 

[Ecoboost_xsport]

How to Install the Aquamist HFS4v3.1 Direct Port Methanol Injection System [Step-By-Step Guide]

Wow, well this was a project that took a VERY long time to complete…I’d say roughly 2 years from date of purchase to finally injecting methanol. It also took quite awhile for me to get this write-up completed. Lot’s of reasons, but mostly just got busy and was sidetracked by so many other...

www.fortheworkshop.com