Clutch Specs needed!!!!!!!

[havier]

Does anyone know where i can get the flywheel to crankshaft tourge specs and the pressure plate to flywheel tourqe specs.

 

[RStalveyARFF]

65 lb ft for the flywheel, 25lb-ft in 2 star pattern stages for the pressure plate. Make sure to use blue loctite on both sets of bolts!

 

[NotSoSlowSHO]

Isnt there a torque sequence?

I torqued them all like torquing wheel lug nuts. And did it in 2 stages shrug

<small>[ March 21, 2004, 02:42 AM: Message edited by: NotSoSlowSHO ]</small>

 

[revhardSHO]

two stages on both
flywheel - first is 38lb then 60-65lb

pressure plate - first is 20lb then 24lb

Blue locktite on both sets!!!!

You'll want to cross-tighten the bolts like notslowsho did.

 

[woody32]

center force dual friction (dont know that part # ) and ram clutches part # ram-88554r (p/n is from summit so it may be a summit only p/n )i never have even seen mentioned in the forums either of these two clutches and was wondering why ? these can't be too awful of clutches,and if we gotta spend $310- 460ish for a clutch for our cars.
i was just wondering,and if there are guys on the forums who have used either of these two clutches,please post about them.