Clutch problem!

[91 shonice]

Hey Guys, I just finished instaling a new stock clutch and TOB. However it doesn't seem to release the clutch completely. Could it be the clutch cable? Really stuck on this. Any ides?

 

[St Louis SHO]

Did you manually adjust it?

 

[91 shonice]

Did you manually adjust it?

I honestly don't know how that would be done. please tell me where to begin.

 

[zak]

Clutch disc installed facing the right direction?

Don't drive it until you get proper release, or you'll fry the synchros

 

[91 shonice]

yes proper direction

 

[rbruso]

I honestly don't know how that would be done. please tell me where to begin.

Pull up on the clutch pedal. You should hear the pawl click once or twice. Then try the clutch again.

 

[91 shonice]

I readjusted the clutch cable and same issues. The car starts to jump if I start the car in 1st. And I cannot shift the car while driving. Any ideas? still stumped?

 

[sperold]

I'm with Zak, that clutch disc may be in backwards. Do some searches on this forum and you can compare those posts with your situation.

 

[jmpSHO2nd]

The clutch disc can be installed two different ways, the right way and the wrong way, sounds like yours may be in backwards. If it was me I would pull the transmission back out and check. It should be labeled engine side and if you can read that it's in wrong. Good Luck.
Quan xi nam Dam ngu sexy Do lot cao cap ao lot cao cap http://doxinh.vn/danh-muc/do-so-sinh-cho-be/bao-chan-bao-tay/ Cho thue trang phuc http://doxinh.com.vn/danh-muc/do-lot-nam/ao-lot-nam/