Calcon shows no data

[nc89sho]

Have been working with the tweecer in the new track car. caledit works fine, no problems writing to or reading from the tweecer, but calcon only shows 0s for everything. like it's not connected. i have no idea why, and cant find any settings to attempt to correct. anyone got an idea for what to look at?

 

[Toolman]

Unless are you very tied to using caledit calcon, I highly recommend Binary Editor. I am very happy with it, and would never consider going back to caledit/con

Other than that, just make sure you are writing to the chip with the datalog tab enabled and all the parameters you want enabled. You will need to update the write everytime you want to datalog (but you can save the parameters to a file for quick loading)

 

[nc89sho]

will binary editor work with the tweecer rt?

 

[nc89sho]

ok, so i've been doing it wrong.... didn't even see the payload stuff in caledit... ugh.... odviously i don't know what i'm doing. this is nothing like the software for my 240sx.

 

[Toolman]

will binary editor work with the tweecer rt?

Yes, beautifully!

ok, so i've been doing it wrong.... didn't even see the payload stuff in caledit... ugh.... odviously i don't know what i'm doing. this is nothing like the software for my 240sx.

payload, that was the word I was looking for.

 

[SHOtime2511]

When working with Adam @ pops racing he showed me some of the programming errors in the calcon and caledit software,its junk compared to BE.

 

[Phoenix]

I also was never able to make calcon to work , no idea why.

So I bought BE.