Search results
-
B
Bogging anyone?
Well the SHO isn't mines, its my friends. Since i have a gen 2 and don't know much about the SHO in the first place i figured i'd come to you guys for advice. I've been on/off this forum everyonce in a while and have gotten a lot of tips and helpful hints about my car. Well the car is a V8 SHO...- bruce988jl
- Thread
- Replies: 4
- Forum: V8 - Maintenance & Troubleshooting
-
B
Pulled the codes...
Alright i'm new to SHO's and just ran the CEL code test today and these are the codes that i pulled. NOTE: both tests, the car ran a "system OK" the following codes are the ones that were stored... 157 (R,M) Mass Air Flow signal is/was low or grounded – MAF 172 (R,M) Oxygen sensor not...- bruce988jl
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
New coil?
well i pulled the spark plugs out of the car and checked them and then noticed that the car was running on 5 of 6 cylinders. I'm positive it's running on 5 of 6 too. the plug wires are all working, but the coil is less than a year old.. any suggestions or do i have to go and buy a new one? And...- bruce988jl
- Thread
- Replies: 0
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Running rough, computer tested.
alright so as some of you may know my SHO has been running really bad. It dies sometimes randomly, and the idle is at 400 rpms all the time and it sounds like a heavy smoker trying to run a mile when accelerating. I hooked it up to a computer and drove around while the mechanic looked for codes...- bruce988jl
- Thread
- Replies: 1
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Problem with Rim painting...
alright, so i'm new the modding the SHO. My dad has had one forever, it was my first car, and i just used it to get from point A to B (quickly too). But yea i decided to paint my rims. I sanded them down with 220 grit wet/dry sand paper and got all the guck off it. washed it down, dried it in...- bruce988jl
- Thread
- Replies: 11
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
B
Cam Position Sensor
Anyone on here know the part # for a cam position sensor? I called up Watertown Ford (in watertown, MA) and the guy didn't have a clue where to look for the part # for it... I'm still on the phone with him as i type too. Also anyone know how much those things run for on average so i can have...- bruce988jl
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
