Search results
-
S
AC-Coil Removal-Help!!!
I have a 94-3.2 SHO. I have successfully removed the clutch assembly. Now, how do I remove the GD Coil? As you know there is about 3 inches between the coil and the frame. My Snap ring plier removal tool will not reach that deep inside w/the 90 degree tip and I cannot go straight in because of...- sho32g
- Thread
- Replies: 1
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
S
Engine Missing (update read end of post)
Own A 94 SHO ATX, 84,000 miles. Complete upper end redone heads, intake, wires, cps sensor, water pump, plugs,ect. complete. Upon first starting everything was fine and about a week later received engine light, codes pointed to camshaft position sensor. Okay replaced sensor and all has been...- sho32g
- Thread
- Replies: 7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Needed Details on 60K Valve lash, shimms
I would greatly appreciated if anyone could give my detail specs on this procedure. 94' SHO-ATX-75,000 Miles Thanx! Joe- sho32g
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
'94 ATX Trans/filter seal ?'s Pics Inclosed
Here are pictures of the filter that was sold to me by NAPA. Also the filter came w/one(1) orange seal and I also found one(1) inside the orfice pickup tube. Now, when I removed the original filter it came out with one(1) orange seal and the other was left in the orfice tube. Does this use...- sho32g
- Thread
- Replies: 5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
ATX Transmission Filter Question....
I am changing my trans oil/filter on my 94 ATX SHO. When I removed the original ATX filter I noticed there was two orange seals. One on the filter and the other in the pump pick up shaft. Is this correct? When I called my local ford dealer they said that the AX4S ATX trans has what they call a...- sho32g
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Help.. Need torque specs for........
If anyone has the SHO helms manual could you please email or post the following. I need the Torque specs for the following: Front Camshaft Sprocket bolts (6 bolts in all) Timing belt Idler pulleys (2 in all) Water Pump to block bolts Any help would greatly be appreciated. Thanks! Joe- sho32g
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
