So i learned a lesson about the local wildlife around here that also solved my problem. Heres how it goes.
hungry squirrel + braided ground wire = A SHO that wont start + Severed wire + a waste of time looking for problems that dont exist.
I replaced this wire and it started up with no...
OK so i finally got around to removing the atarter and today got it tested at an autozone and it works fine so i am checking all my wiring and cleaning it off. The question i have is there is a wire that i dont know where it came from. I have the positive and negative battery wires and i know...
Well my SHO is not starting and it only makes a slight click from under the airbox. My battery is reading right around 12V when i try and start and the battery was just charged. So i am pretty sure that it is some part of the starter and or solenoid r the wiring to these parts.
Every now and...
Well what my friend and I did to his car when his cable shifter went bad, was go to the junkyard buy a rod shifter for 17.50 and tear out his cable shifter and replace it with the rod; it really wasn't too hard to do.
One good way to clean grease is take baking soda and salt mix in some water to make a paste scrub it in an let it sit a few minutes then scrub it off. Just make sure you wash the surface good with water after you get off all of the paste. You don't want salt sitting on a metal surface over a...
Well i checked the brakes today and from what i had seen they look just like they did before the blow out and they seem to be working now but still no idea why the light would still be on. All the lines and wires seemed to be intact and nothing looked dinged or bent so idk. Thanks for the advice...
Well I was cruising at 95 mph making good time to my college and then I hit something don't know what it was but it broke my tire all the way though. Since i didn't have a camera handy i drew a picture.
Of course my socket breaks when i try to take off the tire so i get a ride to an auto...
Well I drive a 94 ATX and just recently fixed an oil leak and finally got it to pass emissions. For about a week the car ran fine, then just a few days ago I go to start up the SHO and go to work and the engine starts fine but I can't depress the button on my stick to get it out of park. Any ideas?