thanks for the info. Im going to see if the resistor went bad. I know that all my LEDs worked the last time i payed attention to it. I thought it might be a simple circuit. If the resistor isnt bad, i guess i will try to open up the housing and see whats going on inside. I would rather repair it...
Did a search and didnt find much. I found out that my third brake light wasnt working. The last time I remember, it was working. I took off the spoiler and removed it to inspect it. Everything looks good and I am getting power to the harness when the brake is applied. Has anybody fixed there...
I am in the market looking for reinforced motor mounts for my 95 mtx. i have been looking around and found a few places that sell them. I would like to know what some of you are using and you opinions. I seen that sho nut has them and bittersweet sho them, plus shoshop. bittersweet has them for...
thanks for the reply. so is the cat back portion of the exhaust the only thing thats stainless or is the y-pipe also stainless. just want to know so when i change my exhaust. any recommendations for an exhaust system?
i have read that sho's came with a stainless steel exhaust from the factory. i want to know what parts are stainless. is the whole system stainless or only parts of it? on my sho, it looks like the mufflers and tips are stainless but i dont think the rest of it is. the intermediate is developing...
i have a 95 mtx. my abs motor is running when i turn off the ignition. it is fine when the ignition is turned on and the engine running. when the car is running or when i am driving, the abs light does not come on. the abs light use to come on intermittently and it seemed like it was weather...
i think vipers are a good brand and are priced really well. the only thing i dont like about them and some of the others are there is alot more wires to hook up and it makes it harder to do a clean job since there is a satallite relay pack to stuff up under the dash with the main brain. sucks...
i checked all the mounts when i did the clutch job and they all looked good. i dont have any power issues and there doesnt seem like there is any play in the drive train. the car has great power and it drives great. the CE light has not come on at all since i did all the work to the car and all...
when i am driving my 95 mtx down the road, everything is fine, but when i let off the throttle to slow down, the car gets jerky. it also does it when i get back on the throttle. it doesnt matter what speed i am going or what gear i am in. its pretty bad when i am driving the car slow, on and off...
it sounds like the amp for the interior speakers is bad. i would replace the factory radio with an aftermarket radio. get the bypass harness for the amp and wire up the aftermarket radio as you would normally at the dash. you can get the wire harness with the bypass harness at auto zone. that is...
here is my system.
dash: panasonic cq-dfx983u w/ remote
front & rear speakers: stock jbl
amp: rockford fosgate 1001bd
subs: 6 - 8" jl audio w3's dvc 4 ohm in a custom box (can be seen in my avatar)
other stuff: sirius satallite radio, optima red top battery up front, spare battery in...
if you use the factory amp with an aftermarket head unit, it is possible that when you turn up the volume, it gets loud quick(lower volume # on the HU). this is because the signal(sound) is being amplified twice. once from the HU and again from the factory amp. if you are planning to put in some...
yeah. that is the only code that i received when i did the tests. i also checked my fuel pressure today and with the engine off/key on i am getting 40 psi when the pump kicks on and drops to about 32 psi when the pump stops priming. from there, the pressure drops to zero in about 2 minutes if...