Search results

  1. jeremy manlief

    Third Brake Light Question

    thanks for the info. Im going to see if the resistor went bad. I know that all my LEDs worked the last time i payed attention to it. I thought it might be a simple circuit. If the resistor isnt bad, i guess i will try to open up the housing and see whats going on inside. I would rather repair it...
  2. jeremy manlief

    Third Brake Light Question

    Did a search and didnt find much. I found out that my third brake light wasnt working. The last time I remember, it was working. I took off the spoiler and removed it to inspect it. Everything looks good and I am getting power to the harness when the brake is applied. Has anybody fixed there...
  3. jeremy manlief

    motor mount question

    I am in the market looking for reinforced motor mounts for my 95 mtx. i have been looking around and found a few places that sell them. I would like to know what some of you are using and you opinions. I seen that sho nut has them and bittersweet sho them, plus shoshop. bittersweet has them for...
  4. jeremy manlief

    stainless exhaust

    thanks for the reply. so is the cat back portion of the exhaust the only thing thats stainless or is the y-pipe also stainless. just want to know so when i change my exhaust. any recommendations for an exhaust system?
  5. jeremy manlief

    stainless exhaust

    i have read that sho's came with a stainless steel exhaust from the factory. i want to know what parts are stainless. is the whole system stainless or only parts of it? on my sho, it looks like the mufflers and tips are stainless but i dont think the rest of it is. the intermediate is developing...
  6. jeremy manlief

    Where's your temp gauge usually at?

    mine sits right above the A all the time while driving, but when i am sitting, it goes a little above half way up the gauge before the fan kicks on.
  7. jeremy manlief

    abs motor running with ignition off

    i have a 95 mtx. my abs motor is running when i turn off the ignition. it is fine when the ignition is turned on and the engine running. when the car is running or when i am driving, the abs light does not come on. the abs light use to come on intermittently and it seemed like it was weather...
  8. jeremy manlief

    Remote Start/Alarm Systems??

    i think vipers are a good brand and are priced really well. the only thing i dont like about them and some of the others are there is alot more wires to hook up and it makes it harder to do a clean job since there is a satallite relay pack to stuff up under the dash with the main brain. sucks...
  9. jeremy manlief

    jerky on & off throttle response

    i checked all the mounts when i did the clutch job and they all looked good. i dont have any power issues and there doesnt seem like there is any play in the drive train. the car has great power and it drives great. the CE light has not come on at all since i did all the work to the car and all...
  10. jeremy manlief

    jerky on & off throttle response

    when i am driving my 95 mtx down the road, everything is fine, but when i let off the throttle to slow down, the car gets jerky. it also does it when i get back on the throttle. it doesnt matter what speed i am going or what gear i am in. its pretty bad when i am driving the car slow, on and off...
  11. jeremy manlief

    Stock AMP blown. Should I Buy New radio???

    it sounds like the amp for the interior speakers is bad. i would replace the factory radio with an aftermarket radio. get the bypass harness for the amp and wire up the aftermarket radio as you would normally at the dash. you can get the wire harness with the bypass harness at auto zone. that is...
  12. jeremy manlief

    Post your audio/video specs!

    here is my system. dash: panasonic cq-dfx983u w/ remote front & rear speakers: stock jbl amp: rockford fosgate 1001bd subs: 6 - 8" jl audio w3's dvc 4 ohm in a custom box (can be seen in my avatar) other stuff: sirius satallite radio, optima red top battery up front, spare battery in...
  13. jeremy manlief

    Eliminate Factory AMP with Aftermarket HU?

    if you use the factory amp with an aftermarket head unit, it is possible that when you turn up the volume, it gets loud quick(lower volume # on the HU). this is because the signal(sound) is being amplified twice. once from the HU and again from the factory amp. if you are planning to put in some...
  14. jeremy manlief

    Does your MTX scream?

    mine makes a spooling up sound when i am in 3rd gear. i can hear it in 2nd gear but it is more noticable in 3rd gear.
  15. jeremy manlief

    intermitent stall & code 542

    yeah. that is the only code that i received when i did the tests. i also checked my fuel pressure today and with the engine off/key on i am getting 40 psi when the pump kicks on and drops to about 32 psi when the pump stops priming. from there, the pressure drops to zero in about 2 minutes if...
  16. jeremy manlief

    intermitent stall & code 542

    i have a 95 mtx. for about the past week, my sho has been stalling sometimes. the car runs great and when i am driving down the road and come up to a stop light, i am just waiting for the light to change and all of a sudden, my car stalls for no reason. it starts right back up and runs the same...
  17. jeremy manlief

    radio noise

    do you have any aftermarket stereo equipment in the car(head unit, amps, etc.) or do you still have the factory system in the car? aftermarket stereo equipment can cause noise if its not installed correctly. there is a small capacitor mounted on the coil pack that is suppose to remove...
  18. jeremy manlief

    ROD bearing/ main bearing (journals?)

    it is possible to replace the main bearings from underneath the car. i did it to my SHO a couple months ago. the front main bearing(at the oil pump) is very tough to get out and put back in, but the rest is pretty easy. you have to loosen(not remove) all the main cap bolts and the caps...
  19. jeremy manlief

    hard to start after 10 or 15 min or more

    there is brand new spark plugs and wires. both are ford factory replacements and the recommended parts from ford. also brand new valve cover gaskets and plug well seals with no oil leaks. its not really a misfire, more like a hesitation at those rpms.
  20. jeremy manlief

    hard to start after 10 or 15 min or more

    thanks for the replies. i will try to answer everybody. the cam sensor and the crank sensor have been replaced with ford replacements. there is no codes present and it hasnt come on since i did all the work to my car. the CE light did come on before i did the work. cant remember what the code...

Latest posts

Forum statistics

Threads
107,088
Messages
1,181,317
Members
16,153
Latest member
lapochkarr

Staff online

Members online

Total: 370 (members: 6, guests: 364)

Share this page

Back
Top