I apologize SHOtimer, What I meant to say was the compressor. The belts are real loud when the enigine is running. When I turn the A/C on it blows hot air. The mechanic told me that it would cost $1900.00 to fix with new parts. Are there any cheaper ways of doing this. Everytime I try to do...
I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit?
Thanks
I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit?
Thanks
I tried the self adjust and when I pushed up on the pedal it didn't click at all. I didn't want to pull too hard so it it still bucks in reverse.
Thanks again.
OK here goes. 93 MTX 101K. Coming home from school last week and as I go to put it in 1st gear I push down the pedal and attempt to shift into first. No good. So I take my foot off the clutch and try again. This time pedal stayed on floor. I reach down and pedal is floppy. Clutch cable snapped...
I have a 93 MTX with only drivers side air bag. The light flashes four times and then five, Shotimes says that it is Primary Crash Sensor #2 - Not Mounted to Vehicle Properly. I just dont know where this is located. Can anyone help out or should I call Ford.
Thanks
I don't think that the liner is the problem. I was in an accident in September and the hood and liner were replaced. I also can feel it when I start the car and the shifting hasn't been all that great either. Is SHOnut cheapest for motor mounts. A guy said that he would only charge me $80.00 to...
I just read how to detect a bad motor mount on the shotimes page but I am still confused. I am almost positive that I need new motor mounts but when I put the car into first and let off the clutch the whole front of the engine rose up evenly, not justt the right side. But I have noticed that...
Where are the the 2 heater core lines. I noticed early that the upper hose was sucked in and flimsy looking when I first started the car. After a few minutes of driving I checked it again it regained its shape. It was hot but i could still squeeze it together.It seems as though there was only a...
Primary Crash Sensor #2 - Not Mounted to Vehicle Properly.... Does anyone know where this one is located? I know of two. One is by the E-brake and the other is under the glove box.
Just to update, I put more coolant in the radiator the way shotimes said, removing the line from trottle body etc... The large hose(upper?) is firmer now. Where is the lower hose located? Shotimes suggests to squeeze the lower hose to allow the bubbles to pass. I squeezed the large one that goes...
Ok just a couple of quick things that I noticed today...
1- The temp. gauge went all the way to "O" in NORMAL at that time the heat went on and then the needle went back down to the "A".
2-I opened the radiator cap. It wasn't hot but when i opned it there wasn't any antifreeze in sight.
3-...
Thank you all for replying and helping me out.
-BeatDaSHO I had the thermostat repaslced at 59k and the water pump was replaced at 70k
-Scott thanks for the help. Its so embarissing to start the car at 1 or 2 in the morning and hear me squell up the block.
-Mikey I am almost positive that the...