Search results

  1. J

    A/C Condensar Questions

    I apologize SHOtimer, What I meant to say was the compressor. The belts are real loud when the enigine is running. When I turn the A/C on it blows hot air. The mechanic told me that it would cost $1900.00 to fix with new parts. Are there any cheaper ways of doing this. Everytime I try to do...
  2. J

    A/C Condensar Questions

    I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit? Thanks
  3. J

    A/C Condensar Questions

    I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit? Thanks
  4. J

    Snapped clutch cable and more!Long

    I tried the self adjust and when I pushed up on the pedal it didn't click at all. I didn't want to pull too hard so it it still bucks in reverse. Thanks again.
  5. J

    Snapped clutch cable and more!Long

    Will try that and post results. Thanks :)
  6. J

    Snapped clutch cable and more!Long

    OK here goes. 93 MTX 101K. Coming home from school last week and as I go to put it in 1st gear I push down the pedal and attempt to shift into first. No good. So I take my foot off the clutch and try again. This time pedal stayed on floor. I reach down and pedal is floppy. Clutch cable snapped...
  7. J

    Primary Crash Sensor #2

    I have a 93 MTX with only drivers side air bag. The light flashes four times and then five, Shotimes says that it is Primary Crash Sensor #2 - Not Mounted to Vehicle Properly. I just dont know where this is located. Can anyone help out or should I call Ford. Thanks
  8. J

    Motor Mounts

    I don't think that the liner is the problem. I was in an accident in September and the hood and liner were replaced. I also can feel it when I start the car and the shifting hasn't been all that great either. Is SHOnut cheapest for motor mounts. A guy said that he would only charge me $80.00 to...
  9. J

    Motor Mounts

    I just read how to detect a bad motor mount on the shotimes page but I am still confused. I am almost positive that I need new motor mounts but when I put the car into first and let off the clutch the whole front of the engine rose up evenly, not justt the right side. But I have noticed that...
  10. J

    HELP! its cold and heats not working

    Where are the the 2 heater core lines. I noticed early that the upper hose was sucked in and flimsy looking when I first started the car. After a few minutes of driving I checked it again it regained its shape. It was hot but i could still squeeze it together.It seems as though there was only a...
  11. J

    Air Bag light

    Primary Crash Sensor #2 - Not Mounted to Vehicle Properly.... Does anyone know where this one is located? I know of two. One is by the E-brake and the other is under the glove box.
  12. J

    HELP! its cold and heats not working

    Just to update, I put more coolant in the radiator the way shotimes said, removing the line from trottle body etc... The large hose(upper?) is firmer now. Where is the lower hose located? Shotimes suggests to squeeze the lower hose to allow the bubbles to pass. I squeezed the large one that goes...
  13. J

    Air Bag light

    Yes luigi it is. It will flash 4 times then stop and then 5 times and stop and 4 again and so on.Any ideas?
  14. J

    HELP! its cold and heats not working

    Ok just a couple of quick things that I noticed today... 1- The temp. gauge went all the way to "O" in NORMAL at that time the heat went on and then the needle went back down to the "A". 2-I opened the radiator cap. It wasn't hot but when i opned it there wasn't any antifreeze in sight. 3-...
  15. J

    HELP! its cold and heats not working

    Thank you all for replying and helping me out. -BeatDaSHO I had the thermostat repaslced at 59k and the water pump was replaced at 70k -Scott thanks for the help. Its so embarissing to start the car at 1 or 2 in the morning and hear me squell up the block. -Mikey I am almost positive that the...
  16. J

    HELP! its cold and heats not working

    Just took a look and the coolant is way above the yellow line. Maybe there is too much antifreeze in there? I have no idea... Thanks for helping though slosho
  17. J

    HELP! its cold and heats not working

    No I have not yet but I will shortly. My g/f called just before and said that i left a puddle in her driveway. She said its not oil but it looks like water. Also the other day just out of no where the overflow tank started spitting out coolant! I didn't have the a/c on or anything. A few minutes...
  18. J

    Air Bag light

    I was in an accident at the end of September which caused the air bag to blow. The only problem is that the air bag has been replaced and all sensors but the light is still blinking. Any ideas/suggestions. Thanx
  19. J

    HELP! its cold and heats not working

    Hello everyone. I have a 93 MTX and a problem. Just recently the heat has not been working properly. I usally put the vent on and within minutes it will usally pump lots of hot air. Now, only freezing cold air comes out. I have tried putting it on defrost, floor, panel and floor it only blows...

Latest posts

Forum statistics

Threads
107,088
Messages
1,181,315
Members
16,153
Latest member
lapochkarr

Members online

Total: 485 (members: 3, guests: 482)

Share this page

Back
Top