StealBlueSho
SHO Member
Mods in signature MINUS the Downpipes....not installed yet. These were done on the same day in a temperature controlled room.
Video of the First Pull:
Video of the First Pull:
Gearhead and LMS E30 Dyno Results
- Thread starter StealBlueSho
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
stevelaw_2000
SHO Member
- Joined
- Apr 14, 2018
- Messages
- 81
- Reaction score
- 31
I like the gearhead tune. What's up with the a/f ratio on the livernois? I like the steady a/f of the gearhead. Not that I know anything.
Sent from my SM-N950U using Tapatalk
StealBlueSho
SHO Member
LMS doesn't lock the gears in sport mode.. so we couldn't go WOT until close to 4K rpms or it will start to downshift to second gear.. thus why the enrichment looks funky.. Unfortunately I called LMS several times and a day or so before the dyno was scheduled to inquire about their recommended way to run their tune on a dyno. I was aware of this issue before hand so was hoping to mitigate it before. You can see the blue line has an artificial spike at around 3500rpms because it started to down shift but he was able to ease off the throttle intime..
They have to have a preferred method or they send a tune that can lock the gears in place with the paddle shifter.. looking at their dynos, it appears they don't have this issue. It makes comparing the torque under 4000rpms impossible as its not WOT from that point backwards.
They have to have a preferred method or they send a tune that can lock the gears in place with the paddle shifter.. looking at their dynos, it appears they don't have this issue. It makes comparing the torque under 4000rpms impossible as its not WOT from that point backwards.
stevelaw_2000
SHO Member
- Joined
- Apr 14, 2018
- Messages
- 81
- Reaction score
- 31
I sure like em, can't see that list of mods though. I have the ebar, plugs, Stat and drop in and a tune. What else will help me get those kind of #s
Sent from my SM-N950U using Tapatalk
SM105K
Streetlight Grand Prix Champ/ IG @fafomotorsports
I made 391/470 plugs, drop in, 3 bar, and and AJPTurbo E30 tune only.
stevelaw_2000
SHO Member
- Joined
- Apr 14, 2018
- Messages
- 81
- Reaction score
- 31
Wow, that's fantastic. I don't have or don't know of a 4 wheel dyno in all of Arkansas but I'm looking at one of those apps that uses GPS to measure my 1/4 times to figure my hp/tq.
Sent from my SM-N950U using Tapatalk
SM105K
Streetlight Grand Prix Champ/ IG @fafomotorsports
SBS's SHO is almost a full bolt on car. So his power level is well above just a tuned car.
StealBlueSho
SHO Member
Turbos and Downpipes are purchased... shop is looking at a mid April install time frame with a bit of dyno time to dial it in.
Looking to get it dialed at 475/500 at the wheels.
Sgtmeatsauce1
2013 SHO +pp
Wow good goals. Good luck have fun be safe..
SM105K
Streetlight Grand Prix Champ/ IG @fafomotorsports
Yeah buddy.
StealBlueSho
SHO Member
Updated sheet showing LMS best be GH best.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Updated sheet showing LMS best be GH best.
Sent from my iPhone using Tapatalk
Just like my comparison on my thread. Is yours a true apples-to-apples comparison? LMS was same exact mods, e30, etc?
StealBlueSho
SHO Member
You can’t get a better comparison. Literally drove the car 1.5 hrs to the shop with the GH tune loaded. They put it right in the rollers, turned the massive fan system on, did two pulls. They left the fans running while I reflashed the LMS tune while still on the rollers. Verified that learned octane and fuel trims were still set correctly. Then did two more pulls. There was about a 1/2 hour cool down before the LMS tune was run with the fans blowing sub freezing temps on the car.
Sent from my iPhone using Tapatalk
StealBlueSho
SHO Member
You can’t get a better comparison. Literally drove the car 1.5 hrs to the shop with the GH tune loaded. They put it right in the rollers, turned the massive fan system on, did two pulls. They left the fans running while I reflashed the LMS tune while still on the rollers. Verified that learned octane and fuel trims were still set correctly. Then did two more pulls. There was about a 1/2 hour cool down before the LMS tune was run with the fans blowing sub freezing temps on the car.
Sent from my iPhone using Tapatalk
