Pulling 89' motor

[SS]

Have you guys pulled w/ or without upper intake on? Also what mounting points did you use, i know about the one in the keft front of the motor but where else did you mount the hoist? Thanks for any input!

 

[Yamaha V6]

Intake off, unless you're dropping the entire subframe out the bottom / lifting the chassis up & back away from the driveline.

Pass. Front hoist point, and I use the driver's rear intake manifold bolt location. There's also another boltdown point in that location as well.

 

[K-Dawg]

x2

(Have to lengthen my message; it was too short)

 

[SS]

engine pull

The bolt location is on the head right? And would you know the size of that bolt?

 

[K-Dawg]

Yes, in the head.

M8-1.25

 

[SS]

Thanks for all your help guys, Steve