Quadmasta,
Front door molding. - Accross the top of the SHO molding there are two acorn nuts, one at each end. Between the nuts there are 7 plastic clips with pins that push into plastic bushings.
Across the bottom of the door there are four acorn nuts.
Rear door - top side of molding 2 acorn nuts, one at each end, and five clips with pins that push into bushings.
Across the bottom of the molding are 4 acorn nuts.
The push pins should be gently pryed out of the bushings. They are a "friction" fit.
Check your metal retainers for corrosion.
The rocker moldings are held on with rivets. Some are plastic rivits that can be extracted, other are metal "pop" rivets that have to be drilled out.
Work at it slow and easy. A Helm manual will show you approximately where the fasteners are located. The diagrams are not very good though.
Hope this helps. rangerj
