Is there a trick to connecting the clutch cable to the fork assembly, 94 mtx. I am in the middle of this and having difficulty with getting it attached. Any ideas or tricks? I replace clutch in a 92 and had no problem. I think automatic adjustment is completely to its max. Is there away to release it?
clutch linkage conection HELP!
- Thread starter shocar
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Shoaz
Studly dood
Yes, have someone pull up on the clutch pedal to release the adjustment pawl, then pull on the cable. You'll have a lot of slack when you pull against the adjustment spring (which isn't very strong).
Storm-Chaser
New Member
Have someone pull-up and hold the clutch pedal while you re-attach that clutch cable. Otherwise as soon as they release the pedal it will retension the spring and you'llbe back at square one.
If you're working solo, cut a 6-3/4" length of wood froma 2"x4" and use it to prop-up the clutch pedal. While the service manual states approximately 7"/188mm, their metric math is wrong (7 x 25.4 mm/in = 177.8mm). I found it difficult to get the 7" section I cut under the pedal without a lot of force - even after pulling back the footmat.
If you're working solo, cut a 6-3/4" length of wood froma 2"x4" and use it to prop-up the clutch pedal. While the service manual states approximately 7"/188mm, their metric math is wrong (7 x 25.4 mm/in = 177.8mm). I found it difficult to get the 7" section I cut under the pedal without a lot of force - even after pulling back the footmat.
Similar threads
