clearance specs needed.

[nik97]

I just got my stuff back from the machine shop and I have to check all their work. I don't have a repair manual handy but if someone does can they post the following:

-Connecting rod big end bore and small end(wrist pin) bushing bore(3.2 rods).

-Crankshaft main and rod journal OD/taper.

-Specified oil clearances for rod/main bearings and wrist pins.


Long story short, I took my parts to the wrong machine shop. They "resized my rods but did not grind the caps. They reamed my old bushings even though I told them to replace them if need be. So now I have huge clearances and I need to mic everything to find out what I need to do about it.

 

[Off Road SHO]

Got you covered Nick. They should be on their way soon.

Tom

 

[yamahaSHO]

If you want, send them out to Denver and have the shop that did Terry's, Scott's and my parts do the work. They've been VERY good for us.

 

[nik97]

^ That's an idea, actually. This place ravaged my sh*t and I am having a hard time finding a reputable machine shop here.

I think I'm going to toss the rods they ruined and start over just to be safe. I'll take some measurements tomorrow to see just what the damage is.

Tom, thank you very much.