Hey all, I’ve been blowing smoke out my exhaust at idle so pulled my pcv valve and oil separator. I’m not sure what these are but there’s was a lot of gunk/ plastic chunks inside, and some are still stuck. Can I take this as a “ replace your oil separator”? One plastic chunk shown below.
2010, plastic bits in oil separator
- Thread starter withku
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
skyshadow07
On a mission to get below 4000lbs
I'm no engineer, wait..
Anyways, that looks like a type of check valve. Or at least the remnants to one. A check valve is a simple flapper type of valve that allows flow in one direction but not in the other.
Anyways, that looks like a type of check valve. Or at least the remnants to one. A check valve is a simple flapper type of valve that allows flow in one direction but not in the other.
Similar threads
