SVOFANATIC
Active Member
Was involved in an accident I hit a pole .
Parting the car out unless someone wants to buy the whole car most won't for what I want.
Car has 13 Inch Cobra brakes,full exhaust Sho Source Catless Equal lenght Y pipe and Dyno Max cat back, 3.2l swap, new taylor plug wires, all maintenence under the sun, New everything drivetrain wise pretty much besides the Tranny, 15K clutch, 105K motor, I have other spare parts as well like another 3.2 block minus pistons and rods, and freshly rebuilt heads with 5Kish miles on them. You can look in my sig and see what the car used to look like the only thing on the car not forsale are the tires will be going on my new car.
Car is complete as of now I would like to have a buyer for the engine before I start parting bits and peices of the car that are used to keep it running (don't want the motor to sieze) I have been starting the car every week and letting it idle for 15 mins before shutting it off also rev it a few times to 3k rpms. This doesn't mean I won't but I'm not gonna sell say a fuel line or CCRM before the engine is sold not like Transmission I'll sell that before the engine that's no issue.
Pricing wise
EVERYTHING IS BEFORE SHIPPING
CV AXLES 7K mile passenger side $75 12K mile driverside $50 $110 for the pair
94-95 spindles 7K mile bearings $110 shipped.
Good CV Intermidiate shaft $60
Battery tray $20 some surface rust
K&N drop in filter $25
SHO shifter boot $20 drying out
Shifter **** $20 stiching coming apart
Sho Source catless equal length Y pipe has been welded SOLD
Dyno max cat back needs either a muffler or the old one welded back on. NO LONGER FOR SALE TOO DAMAGED
Relized the Y pipe in the back it twisted up. SO not for sale the mid pipe is for those who want to do a Rod shifter swap $50
Cobra's SOLD
Wheels 17x8 SOLD
Transmission (STOCK NOT WELDED) SOLD
5Kish Mile 3.2 Cylinder heads $250 obo I'm open on these since I don't know exact mileage just know they are really fresh.
ENGINE 3.2 ready to drop into a mtx will include everything to run $300 105K miles I have a dyno sheet for the engine 191ft/lbs 188Hp
new water pump, belts, hoses, radiator, reinforced MM's, taylor wires the whole nine yards take the motor drop it in ready to go.
Everything is OBO.
If you are interested in buying the whole car PM me I will talk to you about the car and give you a price on it I don't wanna be bashed about what I'm wanting for it I honestly don't wanna part it but $ says other wise I would like to take a shell and pull all my parts on it. I'm not in a hurry to sell the parts so please don't lowball me thank you I've got an emotional attachment to the car after all the work I have done to it now I feel as if I'm taking and ripping it to peices which is what I'm doing.
Car was hit in the passenger side trunk btw so rear windows blown out consider anything in the trunk or the rear deck useless.
CAR IS LOCATED IN MATTHEWS, NC
Parting the car out unless someone wants to buy the whole car most won't for what I want.
Car has 13 Inch Cobra brakes,full exhaust Sho Source Catless Equal lenght Y pipe and Dyno Max cat back, 3.2l swap, new taylor plug wires, all maintenence under the sun, New everything drivetrain wise pretty much besides the Tranny, 15K clutch, 105K motor, I have other spare parts as well like another 3.2 block minus pistons and rods, and freshly rebuilt heads with 5Kish miles on them. You can look in my sig and see what the car used to look like the only thing on the car not forsale are the tires will be going on my new car.
Car is complete as of now I would like to have a buyer for the engine before I start parting bits and peices of the car that are used to keep it running (don't want the motor to sieze) I have been starting the car every week and letting it idle for 15 mins before shutting it off also rev it a few times to 3k rpms. This doesn't mean I won't but I'm not gonna sell say a fuel line or CCRM before the engine is sold not like Transmission I'll sell that before the engine that's no issue.
Pricing wise
EVERYTHING IS BEFORE SHIPPING
CV AXLES 7K mile passenger side $75 12K mile driverside $50 $110 for the pair
94-95 spindles 7K mile bearings $110 shipped.
Good CV Intermidiate shaft $60
Battery tray $20 some surface rust
K&N drop in filter $25
SHO shifter boot $20 drying out
Shifter **** $20 stiching coming apart
Sho Source catless equal length Y pipe has been welded SOLD
Dyno max cat back needs either a muffler or the old one welded back on. NO LONGER FOR SALE TOO DAMAGED
Relized the Y pipe in the back it twisted up. SO not for sale the mid pipe is for those who want to do a Rod shifter swap $50
Cobra's SOLD
Wheels 17x8 SOLD
Transmission (STOCK NOT WELDED) SOLD
5Kish Mile 3.2 Cylinder heads $250 obo I'm open on these since I don't know exact mileage just know they are really fresh.
ENGINE 3.2 ready to drop into a mtx will include everything to run $300 105K miles I have a dyno sheet for the engine 191ft/lbs 188Hp
new water pump, belts, hoses, radiator, reinforced MM's, taylor wires the whole nine yards take the motor drop it in ready to go.
Everything is OBO.
If you are interested in buying the whole car PM me I will talk to you about the car and give you a price on it I don't wanna be bashed about what I'm wanting for it I honestly don't wanna part it but $ says other wise I would like to take a shell and pull all my parts on it. I'm not in a hurry to sell the parts so please don't lowball me thank you I've got an emotional attachment to the car after all the work I have done to it now I feel as if I'm taking and ripping it to peices which is what I'm doing.
Car was hit in the passenger side trunk btw so rear windows blown out consider anything in the trunk or the rear deck useless.
CAR IS LOCATED IN MATTHEWS, NC
Last edited:
