Search results

  1. loganbro28

    White 1992 MTX SHO / $5,495 / 142,000 miles / Located in Oakland, CA

    Message me if you have more questions or want to see a full high quality walk around video(with interior)/more photos. Link to facebook listing with more photos. The vehicle runs excellent and passes smog with brand new CAT converters. It’s sitting on brand new tires as well. Mechanical Work...
  2. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Well, I think we fixed it. We replaced the crank position sensor, water pump, main seal, and timing belt. It seemed that the old CPS was the issue. After installing the first CPS backwards and subsequently ruining it, we finally installed it properly (which we were able to do without removing...
  3. loganbro28

    Replaced Crankshaft Position Sensor, now car cranks but won't start...

    well, we figured out the problem... hate to say it, but we put it on backward. It was cracked open and broken. Now is time to buy another CPS. The question is, which one to buy? https://shosource.com/products/ols/products/crankshaft-position-sensor-89-95 sho source for $140 or rock auto for...
  4. loganbro28

    Replaced Crankshaft Position Sensor, now car cranks but won't start...

    Before reading this post, check out my original post explaining my original diagnosis: https://shoforum.com/threads/uh-oh-cranks-but-won%E2%80%99t-start-when-it-does-start-it-died-at-idle-92-sho-mtx.146552/page-2#post-1601922 So after getting the 211 code, I bought a replacement CPS from...
  5. loganbro28

    Stuck on lining up the timing belt!! 100+ tire rotations...

    Thanks so much for the help y’all!! I’ll update the thread when I work on it next. Sent from my iPhone using Tapatalk
  6. loganbro28

    Stuck on lining up the timing belt!! 100+ tire rotations...

    Hey all!! Thanks again for everyone's help diagnosing my 92 SHO MTX in my previous post. So I ordered a timing belt, water pump, main seal and CPS. Shout out shosource. My brother and I got around to tearing everything out, with instructions from Uday Kamath. It went pretty smoothly except...
  7. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Ok so it wasn’t the coolant (i was feeling hopeful) i drove my buddy home warmed it up. Stalled it at his house. Wouldn’t start. Fiddled with the temp gauge harness, ICRM, DIS then it fired up. Almost got home and it died and the engine light came on (not because I stalled it this time)...
  8. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Is it possible it could have been low coolant?? I added coolant to my reservoir last night because it was pretty low… I ran tests this morning warmed it up a ton, ran both tests multiple times. I pulled a 411 idle higher than expected but I think it was because I hit the gas at the wrong time...
  9. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Thank you for the details I will try and inspect it later today. Hopefully I can find my multimeter too. Sent from my iPhone using Tapatalk
  10. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Was your temperature gauge showing incorrectly too? Or fans failing to go? Or did it just not start. My gauges and fans seems to be fine. Also the issue is causing mine to die. I will try pulling that if I can figure out where it is. Sent from my iPhone using Tapatalk
  11. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Well I ran the KOEO and KOER tests with my dad about 4 times each and the only code it threw was 116( coolant temp higher or lower than expected) the first time because I think the engine wasn’t warm enough yet… so we jammed out in the kicking sound system for a minute and then tried to take it...
  12. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    I ordered one this morning and it got here already. I am currently reading and annotating the manual. Hoping this will give me some good info. Sent from my iPhone using Tapatalk
  13. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Oh ok thank you! Got the acronym confused. Sent from my iPhone using Tapatalk
  14. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    I noticed that when It died and I try to crank it again, that the tachometer does move as it should. Someone said that means it is likely not the CPS. Thank you for the link I will buy a code reader and try to pull the codes. I just turned it on and warmed it up. Again its only when its warm...
  15. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Not sure when it was changed last. I guess I’ll start with that. Sent from my iPhone using Tapatalk
  16. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    So I started up from cold. Started good. Ran it hard driving around for 25 minutes or so. Soon as I parked it and it was idling it died and wasn’t able to start again. Sent from my iPhone using Tapatalk
  17. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    Ok so I was able to find the piece of paper that has some codes that got scanned by my mechanic. KOEO: Fast or first memory (can’t tell) 332: EGR - valve (can’t tell exactly) 542: Fuel Pump CKT KOER: No Code So now I got a better idea of what to try first… Vaccum leaks and maybe a new CCM...
  18. loganbro28

    Uh oh. Cranks but won’t start. When it does start it died at idle. 92 SHO MTX

    SOLVED: The issue was a faulty Crank Position Sensor. So this issue has been happening for a few weeks now. I go to show my friends the car and it won’t start. I wiggle around the CCM because I took it off to crank the engine before I fired it up for the first time after changing rod...
  19. loganbro28

    1992 airbag light coming on.

    Mine has the same issue did you ever figure it out?
  20. loganbro28

    Something fell off my car while driving

    Can confirm it was the foglight bracket, thanks for the help everyone. Here is the passenger side where it fell off vs driver side. Sent from my iPhone using Tapatalk

Latest posts

Forum statistics

Threads
107,107
Messages
1,181,447
Members
16,164
Latest member
313tiger

Members online

No members online now.
Total: 1,613 (members: 0, guests: 1,613)

Share this page

Back
Top