Search results

  1. overthehill

    help on engine code 14

    Mine has not had a problem with dying. It starts up promptly and runs but I am now getting a rough idle, a bad miss under load and popping on initial tip-in. Almost like a lean condition. The car has the original crank sensor and cam sensor with 175K.
  2. overthehill

    help on engine code 14

    I could use a bit of help here from those more experienced than I. My '89 has begun running rough, hesitating and sputtering. I did my best to run the codes with the paperclip test. On the engine off portion I got a code 14. I did a search on "engine code 14" and did not come up with any usable...
  3. overthehill

    Brake pad mileage?

    I really don't see how these brakes have lasted as long as they have. I will admit that a fair amount of the miles were highway miles but still. I did have to replace the rear brakes at 165K due to the left caliper sticking and wearing out the pads on that side.
  4. overthehill

    Brake pad mileage?

    Hi, I have an '89 that I bought new. It has 175K miles on it now. I still have the original brakes on the front and they still have about 1/4th of the pads remaining. Is this unusual? I have never gotten this many miles out of a set of brakes.
  5. overthehill

    3.0 oil pan removal tricks

    I live in Harrisonburg.
  6. overthehill

    3.0 oil pan removal tricks

    Hi, I have an '89 that I bought new. It now has 173K miles on it and has been carefully maintained. I have noticed a "rattle" of late at maybe 2-3,00 r.p.m.s. It's not severe but noticeable. Could this be the rod bearings that I have heard so much about? Is there an "easy" way to pull the pan...
  7. overthehill

    Cooling fan stays on after engine shutdown

    That's what I thought but I thought I'd put it out there anyway. You never know.
  8. overthehill

    Cooling fan stays on after engine shutdown

    Hi, My '89 has just recently started doing this cooling fan run on thing after I shut it off. I tapped an the IRCM module and the fan quit. I have to assume the swich is sticking in the on position. Are these units available anywhere? Any help on this would be appreciated. I checked the...
  9. overthehill

    '89 Speedometer/Odometer Issue

    Speedo cable lube I have had trouble over the years with the speedo making noise on my '89. It also causes the needle to waver a bit. I disconnected the speedo cable under the hood where the lower section and upper section meet. I pour some parts store speedo cable lube in the short section...
  10. overthehill

    Trun signal relay testing....

    I wonder if anyone can advise me on a procedure to check a turn signal relay to see if it is functioning properly. I know I could just go buy a new one and see if that makes a dif. I just like to be able to diagnose the one I have. Call me frugal but spending $40 for nothing is such a waste...
  11. overthehill

    Less than stellar gas mileage.

    I would second the recommendation of using 91 or better octane fuel. Makes a difference as it allows more timing advance which usually always improves fuel economy. I am fortunate that in the area where I live (Virginia) many places have gasoline without ethanol. I can see a 10% improvement...
  12. overthehill

    I am new at these codes, can someone help...........

    Thanks for the response. I am a bit stumped by this problem. I've had the car since new and it has about 150K on it. It has run exceptionslly well until just the other day when it started misfiring under load and popping thru the the intake. Sounds like a lean condition to me but none of the...
  13. overthehill

    I am new at these codes, can someone help...........

    My '89 started running rough quite unexpectedly the other day. I got on the website and figured how to pull codes which I did but I'm not sure how to read them. Engine off i got 11 and 14. Engine on I got 12 and 25. Can I get some help here? Thanks

Latest posts

Forum statistics

Threads
107,085
Messages
1,181,292
Members
16,153
Latest member
lapochkarr

Members online

Total: 444 (members: 2, guests: 442)

Share this page

Back
Top