Search results
-
J
A/C Condensar Questions
I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit? Thanks- Jamz SHO 813
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
A/C Condensar Questions
I need a new A/C condensor. The belts are very loud and A/C blows hot air. Mechanic says that the bearings are bad. Is there anyway that you could just replace the pulley or do have to replcae the whole unit? Thanks- Jamz SHO 813
- Thread
- Replies: 7
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
J
Snapped clutch cable and more!Long
OK here goes. 93 MTX 101K. Coming home from school last week and as I go to put it in 1st gear I push down the pedal and attempt to shift into first. No good. So I take my foot off the clutch and try again. This time pedal stayed on floor. I reach down and pedal is floppy. Clutch cable snapped...- Jamz SHO 813
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
Primary Crash Sensor #2
I have a 93 MTX with only drivers side air bag. The light flashes four times and then five, Shotimes says that it is Primary Crash Sensor #2 - Not Mounted to Vehicle Properly. I just dont know where this is located. Can anyone help out or should I call Ford. Thanks- Jamz SHO 813
- Thread
- Replies: 1
- Forum: Gen 1 & 2 - Electronics & Audio
-
J
Motor Mounts
I just read how to detect a bad motor mount on the shotimes page but I am still confused. I am almost positive that I need new motor mounts but when I put the car into first and let off the clutch the whole front of the engine rose up evenly, not justt the right side. But I have noticed that...- Jamz SHO 813
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
Air Bag light
I was in an accident at the end of September which caused the air bag to blow. The only problem is that the air bag has been replaced and all sensors but the light is still blinking. Any ideas/suggestions. Thanx- Jamz SHO 813
- Thread
- Replies: 5
- Forum: Gen 1 & 2 - Electronics & Audio
-
J
HELP! its cold and heats not working
Hello everyone. I have a 93 MTX and a problem. Just recently the heat has not been working properly. I usally put the vent on and within minutes it will usally pump lots of hot air. Now, only freezing cold air comes out. I have tried putting it on defrost, floor, panel and floor it only blows...- Jamz SHO 813
- Thread
- Replies: 19
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
