Recent content by JLaughto
-
J
Stall less than 1 mile and no RPM's
Found error codes Looks like I have a 212 and 214 error code stored in memory?- JLaughto
- Post #2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
Stall less than 1 mile and no RPM's
93 ATX - Will start,but dies less than a mile down road. The CPS has been replaced, When running has great power, but the TACH stays at 0? any ideas, it happened overnight? Thanks,- JLaughto
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
93 ATX Will not run correctly
Thanks, It was my CPS or Crank Position Sensor due caused from a newly replaced hose that was leaking, Thanks for the help,- JLaughto
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
93 ATX Will not run correctly
Dead I think I'm done, the garage said no errors codes are displayed. It's not worth it when odd electronical problems start to pop up. Engine light is on, it's getting a bad fuel mixture, and is very hard to start. Maybe something died, it's goit 144k on the car, but ran perfect the...- JLaughto
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
93 ATX Will not run correctly
About 6 months ago had a complete overhaul, back to factory spec's. Noticed the car seemed to have problems starting this winter. Yesterday when starting it hiccupped and has not been acting correct since. The car will start, but seems to burn oil now(white smoke), rough idle, and...- JLaughto
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
