i really need some good ideas any help would be appreciated i have a 91 sho and i have a rear main seal leak shrug i have replaced it two times and i've noticed a groove on the crank cuss what can i do? do they make a speedy sleave? cry please help i don't want to put a crank in it thank you headbang
rear main leak
- Thread starter freqsho
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
JoeHoe_SHO
SHOPUKE
Sounds like bad knews to me myfriend. Welcome to the forum! Not sure about the sleeves...
My advice would be to get another 3.0 SHO engine...you can get one on e-bay, or sometimes on this forum from anywhere from 150-600 bucks. Or if you are inclined enough, get your self a 3.2 and keep your 3.0 cams and you'll have a 3.2 MTX(which I personally would love!) Good luck w/either option!
BTW- If it is black and you decide to part it out, I could REALLY use a driver side fender! At the same time, I hope you don't have to part it out. Is it a SHO Plus?
<small>[ July 01, 2003, 12:24 AM: Message edited by: JoeHoe_SHO ]</small>
My advice would be to get another 3.0 SHO engine...you can get one on e-bay, or sometimes on this forum from anywhere from 150-600 bucks. Or if you are inclined enough, get your self a 3.2 and keep your 3.0 cams and you'll have a 3.2 MTX(which I personally would love!) Good luck w/either option!
BTW- If it is black and you decide to part it out, I could REALLY use a driver side fender! At the same time, I hope you don't have to part it out. Is it a SHO Plus?
<small>[ July 01, 2003, 12:24 AM: Message edited by: JoeHoe_SHO ]</small>
sdpatt
Sr. SHO Engr.
I believe that there may be a repair sleeve. I recall seeing one for the front main oil seal at NAPA.
Kevin Airth
New Member
Are you changing the carrier gasket also? I changed the rear main when I had the tranny out and did not change this. Still had the leak. It's Ford Part #E9DZ-6C335-A.
Similar threads
