Check Engine Light?

[URLACHER54]

my cel light comes on and i pulled codes and i am gettinga 332 insufficient egr flow detected, i cganged the egr valve and i still get the code. how do i reset it or could it be the dpfe and where can i get one?

 

['94SHO]

Sounds like you need to clean your "nostrils". Take off the plastic intake piece
so you can look into the T.B. You need a big can of your favorite cleaning agent, and a coat hanger. Thin is better than thick. Prop your butterfly open.
you will see two openings on the bottom of the T.B. Soak the *** out of these
holes. You will need to bend about 1-1/2 inch at the end of the coat hanger
about 22 deg.? Work the spray and wire till you dig out all the chunks.
If you clean out all the egr passages, it would probably help a lot. It did for me.
We spent a good while cleaning chunks out of mine.. (thanx cowsareholy!!)

 

[oldshoman]

Good Advice

I cleared the code by just spraying cleaner in the throttle body AND running 5 ounces of SEAFOAM through a vacuum tube. The code cleared and upon emissions inspection compared to last year HC dropped 80%, CO dropped 1100%, and NO dropped 65%

 

[URLACHER54]

ok did both today used the coat hanger and throttle body intake cleaner and it didnt seem to bad then i used the seafoam (i used the line on top of the throttle body hope it was the right one) and changed the dpfe and still have the CEL light (code 332), what next, anybody help me (also the egr valve is new)

 

[doclees]

got the same type of issue. Mine started over a year ago and I wasted about $400 at the dealer. Got a new EGR with no change. Had it back at no charge. No change. I just finished the upper 60k and cleaned the sampling ports and the path to the EGR. Thought for sure this would fix it since they were plugged. Came back on during my test drive. Time to pull codes again and see what is left.

P.S. urlacher54 any issues with a slow setting cruise control?

 

[URLACHER54]

yea these cars baffle me thats why im selling it, lots of money and lots of time.

 

[doclees]

No mystery is no excitement. A 58 Rambler won't give you any mystery. Hmmm sounds pretty good right about now after working in an engine bay for Gnomes.

 

[oldshoman]

check tubing

Check the tubing attached to the EGR. I found a small break in one. That would give you a code 332

 

[doclees]

Do you mean the hard plastic vacuum line??

Where do you get this hard vacuum line?

 

[oldshoman]

Not sure where you can get it, but you might find something generic at autozone. I was changing my rear plugs the other day and forgot to hook a hose back up and got a check engine light with a 332 code. I plugged it back it and it cleared