Search results

  1. T

    Cranks, but doesen't spark?

    Last night we got the car to start for a split second and then it died immedietly. After that we had no luck. I tried it this morning and it started. I didn't drive it because I didn't have the accesory belt or pulleys on ( I wanted to make sure it started first) but it seemed to run fine. then...
  2. T

    Cranks, but doesen't spark?

    Well I got done replacing the spark plugs/wire,seals, and timing belt. At first it had spark but it wouldn't start. Now it has no spark but the rpms are around 500 when I crank it over. Could this be the crank position sensor? The car did run a days ago,but then had to be torn down to fix a...
  3. T

    Water pump O-ring

    Where can I get the block to water pump O ring? My ford dealer says they don't make them anymore, but suggested that I check out a hydrolic supply store. Is there any aftermarket company's making this part? Thanks, toby
  4. T

    Timing Belt tension

    Yes I did remove the pulley. Thanks for the help guys. -Toby
  5. T

    Timing chain tensioner

    Thanks for the replies! That clears that up. I've been using 10w30 valvoline. Thanks again, toby
  6. T

    Timing chain tensioner

    I have the valve covers off the taurus, and I noticed that the front bank of cylinders has the automatic tensioner, but the rear bank has a different type of setup with no tensioner. I'm wondering if this is correct, or if someone replaced the back one at one time. There seems to be quite a...
  7. T

    Timing Belt tension

    I'm in the process of replacing the timing belt on my 93 auto sho. I'm wondering how to get the correct tension on the belt using the pulley with the offset bolt hole. I've heard you need a special tool. Where do you get it? How much is it? What it the procedure? Is it absolutly nessisary...
  8. T

    Left side of engine filthy

    Well I took of both valve covers to replace the spark plugs when I noticed the back three cylinders are a considarably amount dirtier than the front three, it almost looks like the oil is baked on there. Any ideas why this could be? Thanks alot, Toby
  9. T

    Fel-Pro seal set?

    Anyone know where I can find the Fel-Pro seal set for a 3.2? I've looked around no one seems to have them though. Thanks, Toby
  10. T

    Replacing Spark plugs/ seals

    Well my car misfires a lot, and there is oil in some of the spark plug walls, could the spark tube seals be bad? How do I get the back spark plugs out? Do I have to remove the intake,if i'm doing the tube seals? thanks a lot, Toby
  11. T

    fuel pump relay?

    Thanks for the replies, I also got code 543 (O) Fuel pump monitor circuit shows no power - Power / Fuel Pump Circuits Could this be the relay or the fuel pump itself. The fuel pump whines alot at idle and cuts out alot in daily driving. Thanks, Toby
  12. T

    fuel pump relay?

    Anyone know where the fuel pump relay is located on a '93 automatic? Thanks in advance, Toby
  13. T

    trouble code question

    Just wanted to say hi, this is my first post. Anyways I have found these codes on my car...10, 172, 173, 176, 177, 543, and 111. I don't have a book on my car so it would be nice if you guys could help me out with these. Also the car seems to hesitate, and I can hear it whining by the fuel pump...

Latest posts

Forum statistics

Threads
107,085
Messages
1,181,300
Members
16,152
Latest member
lapochkarr

Staff online

Members online

Total: 378 (members: 4, guests: 374)

Share this page

Back
Top