Recent content by Zimney1

  1. Z

    Stalling-last try

    Thanks for all the input. Can I get that MAF connector from Autozone, etc., or is that a dealer only part?
  2. Z

    Stalling-last try

    Thanks, I'll check that. Could oil in the plug wells cause this? In checking some things yesterday, I noticed some oil in the 2 driver side rear plug wells. Now that I know, I'll be replacing that gasket.
  3. Z

    Stalling-last try

    Need help once again. Just had the codes read at Autozone. Came up with a 212-IDM circuit failure and 215-Coil 1 primary circuit failure. Question, Is there any way to test the coil before replacing it. Will this stall the motor?Could I have bad plug wires? The car has been experiencing...
  4. Z

    Help-SHO Engine problem

    Ok, here's an update. Had the codes reread and they came up the same. Checked the EGR valve operation and it is fine. Just ordered the DPFE sensor. Car now seems to be running fine, however, I drove it about 60 miles and the tach quit working for about 55 miles and then came back on. Engine...
  5. Z

    Help-SHO Engine problem

    I have not retested for the codes. The original codes are as follows: 335-dpfe sensor voltage higher or lower than expected. 327-dpfe output circuit below minimum voltage. 332-egr valve opening not detected. 212-idm circuit failure/SPOUT circuit grounded. 214-CID circuit failure. Could the...
  6. Z

    Help-SHO Engine problem

    I've got problems w/ my SHO that I cannot figure out. The car had been dying intermittently. After some research on this site and others, it had the classic symptoms of a failed crank sensor. I had it at the Ford dealer prior to this and they had codes 335, 332, 327, 212, 214 come up. They...
See more

Latest posts

Forum statistics

Threads
107,080
Messages
1,181,220
Members
16,144
Latest member
14blkbeauty

Members online

Total: 472 (members: 1, guests: 471)

Share this page

Back
Top