Recent content by sxavior
-
S
My 93 ATX Problem
Well the ATX was overfilled, and it ran good for one day and now it back to the same crap. :rant: 1- I figured out most of the time it sticks from 3rd to 2nd but occasionally it does it in other gears. 2- The o/d cancel switch does not seem to be working. 3- You can tell when it is not...- sxavior
- Post #7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
My 93 ATX Problem
We'll it seems that I did overfill the tranny by about 2 quarts. I took out 2 quarts of fluid and after about a day of driving it no longer has a problem. I didn't get to test the overdrive much, but how many rpm's should it be dropping from OD to third? I couldn't notice the overdrive kick off...- sxavior
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
My 93 ATX Problem
It seems like everyone with a 93 has a sob story about their ATX. My story: When I am driving on the highway and I either accelerate enough to downshift or I am going up a hill and the tranny downshifts it will not upshift back to the higher gear once I let my foot off the gas. If I come to a...- sxavior
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
AC problem, short or relay?
I just wanted to give an update, in case anyone has a similar problem. The blower control module($200) was broken and was causing the short.- sxavior
- Post #3
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
AC problem, short or relay?
I have a 93 SHO. The ac just stopped blowing cold air the other day. I checked the freon and it has a good charge. The ac fuse was blown so i replaced it but it blew again. I think it is either a short in the line from the fuse panel to the compressor(I hope it's not this) or possibly the relay...- sxavior
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
Starter Wire
I just thought I'd give an update. The starter was the problem (replaced) and i hooked the red wire to the positive side of the solenoid. It wouldn't go anywhere else.- sxavior
- Post #4
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
Starter Wire
The wire does not have any connector on it(bare wire). I tried hooking it up to the solenoid, again just a click. I'm gonna pull the starter and get it tested. *Can you upload an image on this post or does it have to be a link to a web site?*- sxavior
- Post #3
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
Starter Wire
I've been reading around and it seems like the starter/wiring is generally a common problem. Well here's mine. I've got the infamous starter click. So i thought i had to replace the starter ( Free replacement warranty on the starter, just replaced 7 months ago by a shop). Anyways i jacked the...- sxavior
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Electronics & Audio
