Recent content by Ray G

  1. R

    Secondaries Controller

    I think so also. I wish it was the IAC valve, I got like 6 of them, some polished up some not. :cool: well I think my IMRC is bad cause I checked the wires for current and they have power so I think the solenoid is bad. I hooked up the vacuum straight thru to make sure the canister is good...
  2. R

    Secondaries Controller

    Your handy dandy manual is correct. I have an LPM so that code is normal. The actual code is 551. So i was a digit off. :) LOL
  3. R

    Secondaries Controller

    I am having a problem with my secondaries opening up. It looks to me that when the car is started the controller for the secondaries engages and closes the secondaries. Is this true?? I am getting a 511 code for the IAS check, I think this is for the secondaries. I would also like to know...
  4. R

    Secondaries controler

    I am having a problem with my secondaries opening up. It looks to me that when the car is started the controller for the secondaries engages and closes the secondaries. Is this true?? I am getting a 511 code for the IAS check, I think this is for the secondaries. I would also like to know...
  5. R

    Little time for inspection

    here are the codes: 157 MAF circuit below minimum voltage 511 EEC processor ROM test failure 542 Fuel pump secondary circuit failure 543 Fuel pump secondary circuit failure 556 Fuel pump primary circuit failure The car will be sitting at an idle then all of a sudden just shut off. it...
  6. R

    Little time for inspection

    My check engine light is on and It stalls out on it's own sometimes. Everything is brand new on the engine. New CPS new waterpump New timing belt SHO SHOP MAF SHO Shop LPM SHO SHOP Y pipe SHO Shop Cold air induction New rings, rod bearings, Main bearings New Valves New Valve seals...
  7. R

    Little time for inspection

    I recently just converted my 94 ATX to a 3.2L MTX. Here is my problem. I have a few plugs that don't seem to go into anything. I was wondering if there is someone here, who lives in the RI area, that I can come and take a quick look under the hood of their car. The wiring I have in my car now is...
  8. R

    Rebuild Kits

    I took a compression test and found that the front 3 cylinders have 30 psi and the back three have between 160 and 210 psi. So I have come to beleive that I have a bad head gasket, because I don't think 3 cylinders could go bad all at the same time. Any other thoughts???
  9. R

    Rebuild Kits

    I have a 94 ATX. It has 133k on it. Last saturday it seems do have shit the bed. read my post here http://www.shoforum.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=17;t=006490 I am looking for a kit to rebuild it. I just want a stock kit. Money is short right now so I have to make due. Anyone...
  10. R

    OIL Everywhere

    No noise at all just progressively got bad. I haven't checked the compression yet. I have to go get a guage. The alternater is fine I had no lights come on. The check engine would come on here and there but that was for EGR valve, or It could be for more than that but I just didn't have a chance...
  11. R

    OIL Everywhere

    I have a 94 ATX last night I was driving and notice that when I accelerated the car seem to rev up but I didn't get any power from it. I thought it could be The tranny fluid but that was fine. Since I was 40 miles from home I tried to make it back. The car started to get worst by not going any...
  12. R

    OIL Everywhere

    I have a 94 ATX last night I was driving and notice that when I accelerated the car seem to rev up but I didn't get any power from it. I thought it could be The tranny fluid but that was fine. Since I was 40 miles from home I tried to make it back. The car started to get worst by not going any...
  13. R

    I've decided, now where's the cheapest place for Konis

    I got my Tokicos at SHOX.com. You have to e-mail them for a quote but it was worth it. I paid 459 for them. Right now they have free shipping on koni's. Try it out won't hurt. Laterzzz
  14. R

    Climate Control module

    Anyone know where I can get a climate control module for a Gen 2. My buttons have had their ass kicked before I got the car.
  15. R

    Power distribution pages

    Alot of peeps have been asking about these, so I scaned them in. The file is on my primitive web site that I put together in about 10 minutes. LOL But here is the link http://members.cox.net/craygo/shodocs/powerdist.exe Hope this helps out Laterzzz
See more

Latest posts

Forum statistics

Threads
107,077
Messages
1,181,195
Members
16,141
Latest member
grapnelg

Members online

No members online now.
Total: 779 (members: 1, guests: 778)

Share this page

Back
Top