Recent content by Q Ship
-
Q
Runs terrible
Hello, I have searched endlessly but can't find a similar problem so I decided to ask directly. A few years ago my 1992 mtx went from running fine to garbage overnight, like a switch. The motor has only about 90000km on it (rebuilt), turn the key it starts then dies, try again same thing...- Q Ship
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Q
Rack and pinion loose
Any ideas SHO community? Broken spring or strut maybe?- Q Ship
- Post #6
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
Q
Rack and pinion loose
So I checked the subframe mount bolts, rack bolts, endlinks, strut tower nuts, torque limiters, motor mounts and everything is tight. I noticed a few things, found some p/s fluid on the right side of the subframe just below the rack but I don't see it dripping and there is no major loss of...- Q Ship
- Post #5
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
Q
Rack and pinion loose
The subframe bushings are less then a year old not sure how old the outer tie rods are but the inner were replaced with the rack last year. Bilal- Q Ship
- Post #3
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
Q
Rack and pinion loose
I think my rack is loose. The other day while driving my steering did not feel right, next day fuild was a little low and when the wheels turn they go a little past the maximum and rub the body. Also there is a squeak type noise when I go over a hard bump, anybody had a similar problem? How is...- Q Ship
- Thread
- Replies: 5
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
Q
EATC problems, please help
That sucks, it cost me $100. Which car might it be from? The ebay seller claimed it was from a 95 Taurus.- Q Ship
- Post #4
- Forum: Gen 1 & 2 - Electronics & Audio
-
Q
EATC problems, please help
One more question, the unit I got has a "norm ac" button and no panel/floor button, what is this thing?- Q Ship
- Post #2
- Forum: Gen 1 & 2 - Electronics & Audio
-
Q
EATC problems, please help
I have a 92 with broken buttons on the EATC so I bought from ebay a unit from a 95. When I hook it up everything works except the fan, what gives? I did notice that the coloured lines that go in the back ( I think they are vacuum lines ) are a little different. The white and black are the same...- Q Ship
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Electronics & Audio
