Recent content by madsho
-
M
93 mtx wont start
ok so i push started the car today..... there was a clunk and then she fired up.......:woohoo: drove it home and tryed to start it with no luck.... :doh:i did notice it is clicking when i do turn it over now..... oh and here is a stupid question but where is the silenoid.... my chilton book says...- madsho
- Post #7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
93 mtx wont start
ok for the last three days when i started my car it seemed like it was a weak start..... then today when i got off of work i went to start my car and nothing..... n o t h i n g .... all lights and electronics work fine... tested the battery and it was fine.... alternator is less than a year...- madsho
- Thread
- Replies: 7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
SHObros Garage
resolved... took a while... but resolved none the less... thank you brian... anyone else out there just give him time... he will make it right it just might take some time :)- madsho
- Post #254
- Forum: Hall of Fame or Shame
-
M
SHObros Garage
:) oh look its the majical forum ive been looking for.... so seeing how goofsho is responding on this forum..... dude ive been waiting almost 4 months for my y pipe and oil relocation kit... ive e mailed you several times with no responces what so ever... so i was forced to get my crap from...- madsho
- Post #242
- Forum: Hall of Fame or Shame
-
M
oxygen sensor?
just tried//// does trhe same thing- madsho
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
oxygen sensor?
just tried and it does the same thing- madsho
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
oxygen sensor?
ok im at wits end with this damn car..... so originally i replaced my oxegen sensors about 5 months ago due to check engine codes 177 and 171 and at the same time replaced the thermostat and coolant temp sensor for good messure( from what im told a bad cts can cause a rich condition) anyway...- madsho
- Thread
- Replies: 6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
cat smoking
I have this weird thing happening where one of my cats will start smoking when warm... what could this be from... i also noticed that my exaust smokes after the car is tturned off for up to two minutes???? I have been having issues with codes.... 173 and 177 ... so i replaced the o2 sensors and...- madsho
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
Emissions Help
Ok so this all started one day when i threw a check engine code... pulled the code and found out the oxygen sensor in bank 1 was running rich... so silly me figured i should change both oxegen sensors.... so i changed them and all ran well for the first week or so then i threww another set of...- madsho
- Thread
- Replies: 0
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
weird reving
kinda a car newbie hear... what is the air tempurature sensor and where is it- madsho
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
weird reving
ok... got im my car(93mtx) this morining to go to work... and while waiting for it to warm up it started idleing weird... the tach would jump from about 1200 down to 500 and back and forth... at the same time all the lights would dim(at 500 rpm).... turned off the car and restarted it and it was...- madsho
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
M
umm where did the heat go
**** yeah... let all the components dry and put them back in and...... heat.....oh so lovely heat...... the lesson of the week is..... dont take your car through the car wash when it is -30 degrees..:).... would still like some help finding a new blower control unit... i still only have high and...- madsho
- Post #13
- Forum: Gen 1 & 2 - Electronics & Audio
-
M
umm where did the heat go
anyone tell me where to get a NEW bcm.... everywhere i go they have them but it looks nothing like mine... wtf...... and is there a way to test the old components to see if they are functional- madsho
- Post #11
- Forum: Gen 1 & 2 - Electronics & Audio
-
M
umm where did the heat go
ok so i took out the blower motor and the bcm.... both where completly covered in ice and the housing had about an inch of ice on the bottom preventing the blend door from opening.. i have the parts defrosting right now... is the a way to test and see which of these parts need replacing- madsho
- Post #10
- Forum: Gen 1 & 2 - Electronics & Audio
-
M
umm where did the heat go
blower speed control....? same as blower control module....... and could it be the actual blower motor.... there was a nother post where dudes blower motor froze from to much moister... an would this cause me to blow fuses- madsho
- Post #8
- Forum: Gen 1 & 2 - Electronics & Audio
Latest posts
-
-
-
-
-
Finally Upgrading After 18 Months Of Ownership- Latest: Texas Marauder
Forum statistics
Members online
No members online now.