Recent content by fred93sho
-
F
'93 mtx cylinder 1 troubles.
no codes yet, which sucks because a CEL would help at this point, compression test checked out just fine... thank you for the diagram ill double check that, and i hope dielectric grease was used and not antiseize but thats worth a double check too.- fred93sho
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
'93 mtx cylinder 1 troubles.
this has been an ongoing headache hopefully some of the knowledge on here can give me some ideas! any help is appreciated. The problem: cylinder 1 has a slight misfire or just isn't firing as strong as it should. At idle the car pops and backfires every second or so. it smooths out around 3k...- fred93sho
- Thread
- Replies: 7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
4 slicers - pick up for free
Still got 'em. Junking the tires and shipping them anywhere is more involved than I wanted to get, and northeastern NJ is about as far as I'd go. I do drive to south Jersey a lot, but seldom go east. The traffic sucks!- fred93sho
- Post #5
- Forum: SHO Parts - Classifieds
-
F
4 slicers - pick up for free
I have a set of 4 slicers in very good condition, with 4 very tired tires on them. Pick up free in northwest nj. Might be able to deliver or meet.- fred93sho
- Thread
- Replies: 6
- Forum: SHO Parts - Classifieds
-
F
rear view mirror flew off :(
My mirror first fell off about 10 years ago. Since then it's come off again every year or two. I got in recently, first 90 degree day, there it was on the floor. I was going to spend another 5 bucks on the kit and do it myself, when I decided to stop at the windshield repair shop I pass twice a...- fred93sho
- Post #11
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
F
Looking for rim& tire information? Look no further!
wheels Thanks. I'm guessing the guy at Tire Rack might have 1st gen. info.- fred93sho
- Post #59
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
F
Looking for rim& tire information? Look no further!
wheels Tire Rack says 225/50/17, but I wanted a little wider than I have now. The wheel offset is same as stock, 42mm. Does the offset need to change for wider wheels?- fred93sho
- Post #57
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
F
Looking for rim& tire information? Look no further!
wheels question/opinion From what I've read here, I should have no trouble running 235/45/17 tires on 7.5" rims. However - The guy from Tire Rack says the fenders will need to be rolled, and the "speedo difference" calculator warns against going more than 3% from stock. Should I be worried...- fred93sho
- Post #55
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
