Recent content by andy
-
A
Fuel Pressure Problem
I had the 60K done. I currently have 138k but had new plugs/wires and valves adjusted at 110k. The car runs and accelerates smoothly it just the hard start. If the fuel pump is going out would it just die since it is electric. Would it idle kind of rough if it was going out or if the...- andy
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
A
Fuel Pressure Problem
I have a 93 atx. I have to crank it over three times for it to start. I replaced the camshaft position sensor and that did not help. If I turn the key on/off twice for two seconds without engaging starter it fires right up on third attemp. Fuel pump was replaced by dealer at 86K and now have...- andy
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
A
Hard Starting
I have to turn the engine over three times before it will start. It starts on the third cranks everytime. Is this the crankshaft position sensor or camshaft sensor ?- andy
- Thread
- Replies: 5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
A
Rough idle
I have a 93 atx with 135k. Everything still works great except my idle seems pretty rough. I cleaned MAF and plugs and wires are almost new. I don'nt have a code reader . While in neutral I rev up and it cuts out at 3k rpm's. 02 sensors are new. Any suggestions will be appreciated,- andy
- Thread
- Replies: 1
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
