I have a '95 SHO/MTX and am looking for suggestions on installing a coolant temperature gage. With the varying degrees of dependibility of the factory gage I know a lot of people must have done this and have input as to the best gage, best routing of cable through firewall, best place to locate...
The heater hose has a metal end formed on it. I may be able to cut it down and put another hose on the end of it with 2 hose clamps (one on the engine block and one on the reformed end of the heater hose). If that doesn't look like it will work I will have to get a completely new one.
Radiator and tstat less than 2k miles old. I know that doesn't mean they are good but it is an indication that they are PROBABLY good. If the radiator has a problem it show on pressure check. I will test tstat at the same time.
thanks,
adavery
I have a 1995 SHO that is losing coolant. From where I do not know. There are no drips or puddles on the ground. There are no visible wet or damp spots on the enging or the engine compartment. Over the last month or so I have driven approximately 100 miles and have had to add 1 gallon of...
First, thanks for the responses. I have flushed the system completely twice. I have a new 16lb radiator cap. The problem remains. I am in the process of getting a gauge and bezel.
Allen
I don't know is i have an overheating problem or a gauge problem. I have a 1995 3.0 mtx SHO. Bacicly the entire cooling system is new (radiator, waterpump, termostat, temp sending unit). the car can stand at an idle for days and the temp gauge stays between the R and M in NORMAL. If I drive...