Search results
-
T
Loss of power have tried everything!!
I think they are autolite plugs thats all I could afford at the time but they are brand new no pinched wires I made sure of that when I put the intake back on. It could possibly not be seated right I'll have to double check that but yes the butterflies are opening and working as they should.- TheBabbige
- Post #25
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
Everyone be nice I appreciate all the opinions from everyone but assuming now that the gap has nothing to do with my problem then that's a relief now on that note I was out driving today and I totally forgot that this happens but if I'm at a dead stop and try to take off pretty quick the car...- TheBabbige
- Post #23
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
I have had the timing checked and checked it myself the marks are lined up perfectly where they are supposed to be so i can assume that it is in time i have narrowed it down to either being the fuel pump,or the crank sensor not being gaped right because everything else seems to be in working...- TheBabbige
- Post #17
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
Ahh ok i didn't know that i just put it on and bolted it up will have to check into that sorry for the confusion but yes the ground strap is attached and all the bolts to the DIS module are on it the clips that hold the plugs on are broke though if that would cause any problems im not sure but...- TheBabbige
- Post #15
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
I had to replace both sensors cause they failed on me the timing belt cover was removed when i baught the car so i didnt have to take the belt off to get to anything just put them on both sensors were baught brand new so i assume they were within spec the timing belt was replaced when it broke...- TheBabbige
- Post #13
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
Haven't checked the fuel pressure yet it seemed ok of course that don't mean anything I'll try and have that checked what exactly is it supposed to be at? As far as the intake clamps I have removed it several times and they seem really tight so I don't belive its a air leak I'll double check...- TheBabbige
- Post #9
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
Have pulled the codes the only code I have is for the front o2 sensor there is only 1 cat on the car it was like that when I got it the plugs are new and no oil in the wells since the gasket change car used to run fine till I had to change the camshaft and crankshaft sensor since those have been...- TheBabbige
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
T
Loss of power have tried everything!!
OK I own a 95 MTX SHO that runs great just has a loss of power. It start's,runs,and drives great it just don't have the power like it used to have. I have replaced EVERYTHING on this car without going into the motor itself and still cant figure out what it is. It's fine till i try to get it to...- TheBabbige
- Thread
- Replies: 24
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
