Search results
-
B
help! need shifter cable re: '93 3.2 atx sho
Shifter cable grommet question First off, that is exactly what i wound up doing. Busting everything in the way, out of the way with a tire iron. I am finally all most home on this fix. BUT! The fire wall rubber grommet on the shifter cable just won't push in place or fit. I got it off of...- biggmackk55
- Post #8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
help! need shifter cable re: '93 3.2 atx sho
Well i found a sho in the yard of junk! Did not have enough time to finish removal before yard closed. Hindered by carpet and other obstacles atop of cable. I think too i am going to have to deal with a heater duct. I should be able to knock it out, BUT, i am very open to any helpful tidbits...- biggmackk55
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
help! need shifter cable re: '93 3.2 atx sho
Thanks guy. Actually i would be happy to find a sho in the junk yard. I have never seen one there. That is one reason i am seeking to find out if the part is interchangeable with another make vehicle.- biggmackk55
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
shifter cable plastic piece broken; 3.2atx
Alrighty then. Thanks. btw, what was the make, model of car you mentioned?- biggmackk55
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
help! need shifter cable re: '93 3.2 atx sho
Tranny shifter cable plastic part snapped. The section that goes through the bracket. This is a atx, floor shift, cable linkage top of tranny under hood set up. At this point my focus is on 1. where i might find a new cable 2. what other make cars may have compatible part 3. who has a step by...- biggmackk55
- Thread
- Replies: 8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
shifter cable plastic piece broken; 3.2atx
OK, here's the deal. The shifter cable (under hood) near the end that is attached to the top of the tranny at the lever, is broken at the plastic part that fits through the bracket. The shifter stick is not making gear changes. I have been manually moving lever from under hood. Has anyone had...- biggmackk55
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Hose next to thermostat housing?
I would like to know if you were ever able to make that hose repair. If so, how did it go? how hard was it to get to nuts, take off and replace the housing #1, not the t-stat housing/cover. I have to get this same job done. Thanks- biggmackk55
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
O-ring kit 3.2?? Who, where
water crossover pipe o-ring Yeah i see that kit is very available. I may get it. I was looking first to see if i could buy just the one o-ring. Also the o-ring that is already on my car looks to be in good condition. Push come to shove i'll keep it on. I can also take this o-ring into a...- biggmackk55
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
O-ring kit 3.2?? Who, where
I need to put a new o-ring on my t-stat outlet housing. In the block/pipe. Not the therm cover!! My question is; Does anybody know if any of these water pump gasket "kits" include the o-ring needed for replacement? 1993 3.2l SHO. Now naturally if there is some place i can get the o-ring by...- biggmackk55
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
HELP! '93 sho therm water outlet housing
Thank You for sending what i needed. This is totally it!- biggmackk55
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
HELP! '93 sho therm water outlet housing
Totally need some help with a 93 3.2 sho. The deal is i am trying to remove the outlet housing against the block. Pull on it is doing little to nothing. I can wiggle it so i know it should be pullable. Right now if nothing else, i would like for someone to send me a pic of this part. It may...- biggmackk55
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
