Search results

  1. C

    Cancer??rod??Tensioner??

    Thanks for info so far. I'm hoping that it's the tensioner. Will I be ok to drive a little bit for inspection. Tags no good. Hope to hear back from Brian. Can I get the tensioner new from anywhere as I really don't have a place to pull it and Wait to send out
  2. C

    Cancer??rod??Tensioner??

    Oil light has not come on. Oil is clean. She runs good actually pretty dam good with new tranny. No loss of power. Does not seem to effect drivability at all. Seems to be coming from acc timing belt area and transferring into engine. If it is a rod can this be fixed? Original rods. Car has...
  3. C

    Cancer??rod??Tensioner??

    93 ATX i had the cps seal done and after about 100 miles of driving i got a knocking noise. Seems to go away when rpms are high and stays throughout idle. Had the mech steth on it today. Seems to be coming from (looking at engine from front) passenger side corner of engine towards middle...
  4. C

    heater problem?

    Great help. I am leaning toward this myself. Is there a way I can test the bcm. I have read some posts on the bcm. But could not find one on how to test it. If there is a way. I am def interested in part as I have read new it is around 200. Also is the eatc in good condition. My buttons are cracked.
  5. C

    heater problem?

    I just checked on it again. Now it is not clicking on and off. It is doing it very periodically now. When it does do it. It seems that it is shutting the heating system down then restarting. Also it only comes on at full blast even if I turn fan to low manually. Is there a way for the pivot...
  6. C

    heater problem?

    Also it is not showing any codes.
  7. C

    heater problem?

    The fan runs at full blast. I have not left the heat on long enough to see If it is only hot. Is there a way I can check the blower control unit. I have also read some posts that it could be a bad #17 fuse. Is there anyway to check on or get to blend door without ripping dash apart. Thank you...
  8. C

    heater problem?

    I have a 93 ATX with 126k on it. I have had the 60k and trany rebuilt within the last 2500 miles.Got into my car this morning and turned on heat. It is blowing on and off. when it does come on it is at full blast. also i hear a clicking noise in the dash while it is doing this. Heat does come...
  9. C

    93 auto transmission problem

    I have a 93ATX with 126k miles and a fresh 60k. Mine was doing the same thing before the 60k. My problem was the CPS. If it has never had a 60k i would just run the codes to see if one pops up that is easy to get too. But i would highly suggest you start thinking about that.It will make a world...
  10. C

    Tranny upgrades!

    i am looking for firmer shifts and more reliable then factory. thnx for info so far
  11. C

    Tranny upgrades!

    What brands am i looking for on the shift kit?
  12. C

    Tranny upgrades!

    I am about to have my 93ATX rebuilt. What upgrades are available for the rebuild. Also in what order of importance are they.:thankyou:
  13. C

    tranny problem

    Does anyone know of any sensors that could be causing this problem?
  14. C

    tranny problem

    Area 91, believe me i wish i could come back down,but i dont think she will make it with her acting up like this. I am trying to diagnos the problem. I got the VSS changed but did not help. I am gonna go get the 94 comp, and a new TPS. To see if that helps. Good luck with the 94 Opal Frost. I...
  15. C

    New vs remanufactured waterpump

    Reman pump is fine. With the seals go with the motorcraft. They are really cheap. and it makes sense for the couple extra bucks. Because they are a chore to replace again if they do fail. I got mine from directfordparts.com for $7-$10, cant remember exactly.
  16. C

    tranny problem

    Thanks for the info. Is this all upgrades i should be looking for or is there more?
  17. C

    tranny problem

    Where is this and is it easy to replace ? passenger side axle seal! I think this is the problem because i think this is where the leak was coming from.Is there any way to check lines?
  18. C

    tranny problem

    Upgrades done?
  19. C

    tranny problem

    If it comes to a rebuild what am i looking for in upgrades?
  20. C

    tranny problem

    Everything Mark in PDX says kind of hit it the head on the nail, but shoon has a legit point and i am gonna flush system again. Maybe some air got in there. But on what Mark said, is there any tests or tips on how i can check to make sure pressure is good. Because the problem is very...

Latest posts

Forum statistics

Threads
107,087
Messages
1,181,312
Members
16,153
Latest member
lapochkarr

Members online

Total: 402 (members: 3, guests: 399)

Share this page

Back
Top