Search results
-
Y
Turn Signal Problem
Hi gang, yesterday the ol sho quit do to a bad alternator. After replacing the alternator the turn signals/hazard blinker stopped working. I checked the fuse (ok), relay (ok), lights (all work) but now I'm at a loss. Anybody been here before? Thanks- yostie5
- Thread
- Replies: 1
- Forum: Gen 1 & 2 - Electronics & Audio
-
Y
A Real Puzzler
OK people, I have done my due diligence and searched and found answers that seem to dance around my problem so now I'm sending it out to all of you great informants. The SHO (95 atx) normally runs great but lately when trying to start I show no RPMs and engine won't go. It starts to turn over...- yostie5
- Thread
- Replies: 10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Y
Engine overheating
Engine overheating/Head gasket? This forum has been very helpful in the past. Hoping for more. My 95 atx has been diagnosed with combustion gas in the cooling system. Having read previous posts stating that the head gaskets rarely blow in the sho I'm assuming the worst ie cracked head. If so...- yostie5
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Y
AC Blows Hot
Hey all, I just installed a hard button replacement eatc on my 95 and everything seemed to go fine. Prior to this my air would blow cold for 20 mins. or so then go hot. Self test showed no problem and coil was not icing up. After install it now just blows hot all the time. Clutch is engaging but...- yostie5
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Electronics & Audio
-
Y
Short term air
Hello all. Long time reader, first time poster. I have read posts on the blend door problem and have performed the diagnostics but still can't figure out why my ac only blows cold for about 20 min. (every time) and then cuts over to full heat. AC system checks out good. There is a musty sort of...- yostie5
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Electronics & Audio
