My blend door is functioning fine as far as im aware but im removing the interior of the car to do some custom work with fiberglass so while its apart I'm gonna do the heater core and blend door
Its got a oil leak in the back of the engine somewhere and im pulling the motor cuz I want to clean it up. I just lost my license so I figured its time for a project. How do I go about polishing the intake mani and are rod bearings a pain like on other cars? I was thinking about
markvII...
I have a 92 sho 3.0 mtx and I am currently pulling the motor to fix a few things and im looking for some advice on squeezing some more power out of it. I would like to invest $1500-$2000 in the rebuild but don't know much about the sho. Figured this would be a great place to get some pointers...
ran the eatc test and i got 888 and if im correct that means theres no codes.. replaced the thermostat today and it seems to be better but when i took the drain plug out of the rad NOTHING CAME OUT! i immediately took the cap off and the rad was full of fluid i just ended up taking the top hose...
lately as i am driving my car and have the heater on it blows kinda warm air but nothing like my other cars. then it will start blowing cold air. i am going to try to replace my thermostat today cuz were expecting 6-10 inches of snow tomorrow and i have to have my 2 year old son in the car...