On my recently purchased SHO, there are a couple of sections of the lower plastic exterior trim that are slightly discolored. Is there a good product to try and clean that? Also, the front one is pretty scraped up. Is it possible to replace just that lower plastic part? If so, how involved...
I actually went with the LC2I. Seems to work well. I managed to install it without cutting or tapping any factory lines in case I wanted to remove it later. I tapped into the rear speaker inputs, but since I replaced the rear 6x9s with aftermarket speakers at the same time, I just tapped into...
That's a good point. I'll just use the rear speaker input and see how it sounds. unfortunately/fortunately I got my appointment bumped up to get tint done and to get the wheels refinished (previous owner liked to bounce off curbs apparently) to today, so I wont be able to install tonight anways.
Isn't there a way you can tap into the wires BEFORE the amp, that would give a cleaner signal for it? That's kind of where I was going with my question.
So I guess I had a different thought on what a "pre-out" was. I was thinking straight RCA connection :). That's not there lol. So what wires should be used off of that amp with an LC2I? I'll have that coming in tomorrow and am going to try to install my amp/Sub
Are those actual preamp outputs? (I haven't looked yet). Or do they require some sort of line level converter? Where is it located in the drivers side? Just behind the carpet?
I just picked up a 2014 SHO with the Sony sound system & the Sync Touch system. How hard is it to add an external amp and sub to this system. I'm not looking to build a crazy audio system. Just a single 10 or 12 sub for a little extra oomph. Probably nothing more than 250-500 watt. I've...
It does look like they added about 2k in incentives to the 2016 in the last few days. I've been comparing between Used and New 2015/2016. As of a couple days ago the 2015 had 4500 in incentives in my area and the 2016 only had 2500. Looks like they both have 4500 now.
I had already decided...