Recent content by shomanwi
-
S
how to get 13s
My 91 plus went 14.7 stock and 13.9 with a somewhat stock 3.0. I do not think with just bolt-on’s you would see 13’s. In my car I had under dive pulleys, air horn, cold air intake ported throttle body, fully ported intake, ShoShop race cams, custom tune, aluminum flywheel, and drag radials. Also...- shomanwi
- Post #54
- Forum: Engine, Intake, Exhaust and Drive Line
-
S
Sonic
Personally I think that Culver’s has a better burger and with a higher quality level.- shomanwi
- Post #13
- Forum: WISHOC - Wisconsin SHO Club
-
S
power windows
Vary common problem it is probably the master window switch it self.- shomanwi
- Post #3
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
S
outer cv boot
No you cannot properly repair the boot by just patching it, it will leek and the joint will fail.- shomanwi
- Post #2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Tried to swap springs today!!
The easiest way I have fond to remove the lower ball joint it to use a pit-mint arm removal tool.- shomanwi
- Post #22
- Forum: Gen 1 & 2 - Suspension, Brakes & Body
-
S
Which O2 Sensor?
Since you put this thread in the gen 1’s there should only be one set. To answer your question when you ran your diagnostic test it should have said the bank that the oxygen sensor is bad in. If is a gen 2 there are up and down stream oxygen sensors and the test should have said that to. Also...- shomanwi
- Post #11
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Rear brake dragging while driving
You should take off the brake hose from the rear calipers and have someone press the brake to see if there is good flow. I have seen a lot for cars with bad rear brake hoses.- shomanwi
- Post #15
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
S
93 Atx
The last time I had my car at the track it would go 15.2 all day long.- shomanwi
- Post #13
- Forum: At the Drags
