Recent content by nathaluc
-
N
Mechanical Book
I have a shop manual for a 92 MTX SHO if you are interested...- nathaluc
- Post #8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
N
Air is only blowing from defrost vents??
Had the same problem 10 years ago when the dealer did some warranty work on my SHO and forgot to plug back a vacuum line. This is where I would start looking and then move on to the ETAC being faulty.- nathaluc
- Post #5
- Forum: Gen 1 & 2 - Electronics & Audio
-
N
Removing a/c accumulator/line
Thanks for the tips on disconnecting the old drier. BTW, isn't there only one connection at the firewall ? I will not remove anything else than the drier ! My main concern is reinstalling the new drier with its long hose... I don't want to touch any other A/C hose or fuel lines. Is it...- nathaluc
- Post #9
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
N
Removing a/c accumulator/line
jthomas68 (or anyone else!) - Can you give me a few tips on how the drier replacement went ? I was just about to order a new drier & hose and then looked closely at the job... There seems to be another A/C hose running on top of the drier which I don't want to disconnect, I don't mind removing...- nathaluc
- Post #7
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
N
engine stumbling - got codes - *Solved*
Replaced all six injectors with a used set and the problem is fixed...- nathaluc
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
N
engine stumbling - got codes - *Solved*
Well, I checked all plugs & wires, half a drop of oil in plug well #2 which I cleaned but it didn't solve the problem, still #2 weak on cylinder balance test and still stumbling. I listened to injectors and sure enough, can't hear #2 clicking. - can it be effective to do a pro clean job...- nathaluc
- Post #4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
N
engine stumbling - got codes - *Solved*
Weather got down to -20F last week, SHO wouldn't start, had to boost, however hood latch was near impossible to open, probably stuck in old frozen grease, finally got it but broke the latch trying to close it back. SHO sat outside for a few days with the hood not completely shut, snow got on...- nathaluc
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
