Hello to all!
I had to drive from San Francisco to L.A. with no heat over the Thanksgiving holiday in my Gen I black SHO. 31 degrees--outside temp-- had me pretty frosty by the trips end. The buttons all seem to work fine in redirecting flow, say from floor to panel to defroster. But I get NO...
Spout connector
Doug,
Thanks for the advice. I did find the connector, but then was reminded by a friend out here in California that they do a ign. timing test as part of the smog check. Having moved here 10 months ago from Colorado-- I was not aware of this difference in the test. Anyway--...
EGR problem--almost ready to try a pre-test
Thanks for the tip. I did look at that component, and verified that there was vaccuum to it with the engine running. When I put my MitiVac unit to the other port (going to the egr) and revved the engine I saw no reading of vaccuum on the gage. So--...
Thanks for the tips. I did take the EGR valve off, and checked it with my MitiVac Vaccuum Pump, and the shaft did move and it held vaccuum. Then I sprayed out the valve to remove carbon/gum and it operates smoothly now. Then I took the hex plug out of the manifold, and sprayed Berrymans Carb...
Help!!!
I've just purchased a 1990 California SHO that has a problem I'm hoping the membership can help me with. The emissions test paperwork I received with the car showed the following test results:
@15 mph
HC ppm 0014
CO% .2
O2 .3
%CO2 14.8 (All these values...