Recent content by moonbum
-
M
1993 Wont start
I am not far from you. I will remember that if I cant figure it out. Thanks- moonbum
- Post #11
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
M
1993 Wont start
The guy I bought it from said one day it just wouldnt run, ran the night before but the next day wouldnt start. I checked for loose wires, I was told a ground wire could also cause this issue ? I dont see any loose. How Many Ground wires are there on this that may impact it running and where...- moonbum
- Post #8
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
M
1993 Wont start
What should the GAP on the Crank sensor be ? I just ordered a factory manual and dont have it yet... Thanks again.- moonbum
- Post #7
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
M
1993 Wont start
I did not install the crank sensor, I just boughtthe car non running for a steal so I am starting with what I know. I do know the Crank sensor was replaced although I dont have that much faith in the genius that installed it so it may be junk now. It does have a leak at the fuel pressure...- moonbum
- Post #6
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
M
1993 Wont start
More info According to the previous owner it just wouldn't start one day and ran the night before. New crank sensor but don't know if it was gapped right, has power to coil though but no fire when it cranks over- moonbum
- Post #5
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
-
M
1993 Wont start
I have a 1993 SHO with a new Cam sensor, crank sensor and DIS module, the coil has power to it, the cam belt is NOT broken. Car turns over but WILL NOT START and has NO SPARK ??? Can anyone help with any ideas what's wrong ???? Thanks- moonbum
- Thread
- Replies: 11
- Forum: Gen 1 & 2 - Emergency Issues - Help & Maintenance
